Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hello, I found a Homelite 180v hand held 2 cycle blower in the trash. It looks mint. I filled it with fresh 2 cycle and it fired up but will only run with the choke set half way. I removed the carb and it looked spotless but i cleaned it out good with gumout and reinstalled it. same thing. it will only run on half choke. if i shut the choke off it bogs down to a stall. if i put the choke on full as it bogs and then move it to half it stays running. i tried adjusting the 2 mixture screws but still no go. any idea's ??

Knee,
How are the hoses? No kinks restrictions? No cracks? The little filter on the end of the pickup hose is good? How is the fuel pump diaphram? Diaphram spring? Passages to and from the pump?

I'm with 'Lint on this one - compression loss due to a loose cylinder head/block. Very common on the small 2 stroke trimmers due to extreme vibration. Another simple thing to check first is to loosen the gas cap - me "freebie" Sears blower only runs with the cap loose, otherwise it must be run on about 1/2 choke if I forget & make the gas cap tight...

Marty

You guys just covered what I was going to tell him lol. Do all that and let us know how it goes.

I'm thinking the worst case scenerio is that the guy that owned it, ran straight gas (no 2 cycle oil) in it out of ignorance, in which case it's gonna need a lot of TLC. Otherwise what was recommended above should get it running. I know I would have picked it up if I had seen it, because nothing ventured, nothing gained. Best of luck in fixing it up!

I'd replace the whole fuel system, lines, and filter.  A family member has a Weedeater that I believe somehow got dirt in it and scored the cylinder wall, as it's no go. 

Personally, if it runs well on half choke, I'd just leave it on half choke.

LL