Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I inherited my late father's Generac Pressure washer model 1460 and I'd like to change oil and do a little maintenance on the thing.

I've found the owner's manual online here: http://www.generac-portables.com/data/pdf_files/pw/1460_0en2w.pdf

But it doesn't give any specifics on the engine (in fact, the part number on the engine is "NSP", which I assume means "No Specific Part"). I know its a Honda 5.0, horizontal shaft, probably a consumer engine, but I don't know about the oil capacity, or anything else about it. Any ideas on this? Thanks for any help.

I'll check the garage tomorrow, but the cover does say HONDA in big blue letters, so its likely an actual Honda. And I don't want to replace it, I only want to know the oil capacity as I'm getting ready to change the oil.

I believe it takes .63 QT oil. Warm your engine up prior to draining to allow draining of all contaminants. Fill with .63 qt of 5w30 synthic oil. check level with your dip stick to make sure it is full.  If you do not  see any idenification on the pull cord cover, look on the engine above the oil drain plug. The engine serial # is stamped there. You can then go to engines.Honda.com web page . Once you get your serial # you can download a engine manual. If i'm wrong it may be a GC or GS series engine instead of the GX . Eather way it takes .61-.63 qt oil.

Hi Tom,

I did some research today. I have some good news for you.  Your engine model is a Honda GC160, it takes .61qt of oil. You can find more info about your engine  at  Honda outdoor web page just look up engines and your model.  For all other info on parts to your washer you can go to  www.ppe-pressure-washer-parts.com/generac-pressure-washer-model-1460-0-parts  .   They list everything for your pressure washer. I hope that helps

Thanks. I just went out to the garage and as you said, its a GC160. I'm usually pretty observant. I don't know how I missed the GC160 on the rope cover.