Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Ariens 11528DLE

I purchased this sno blower two years ago and I am about ready to install my third auger belt. Anyone else having this problem?

Thought I was buying top of the line, my fathers vintage 1970's Ariens refuses to die and is still throwing snow like new. Very frustrated. Cold weather and no garage is no time to be replacing belts.

Brian

Post a few pictures of your pulleys and belt.  That could help a little.

brjl-Copy the seral # off the plate or sticker on your machine and call Ariens. I can't be specific and I may be entirely wrong but there was I think some discussion a few years ago on a 28" Ariens unit with belt issues. If my memory is wrong I apologize to both you and Ariens.

Marc

I can't get the link to come up. It is from October of 2009. There is a dual belt kit for the 11528 auger drive. I will try to get the link to show..

Marc

I can't get the link to come up but the story is this- Ariens has an accessory kit #72600700 that fits 8.5-11.5 Tec. powered machines as well as  Briggs powered 926xxx machines. It was designed for 2005-2006 units and became standard on the 2007. If you would like to read the whole thread Google "Ariens twin belt kit". The second listing is the thread here on Abby's that you need to read. Snowmann's response in the thread is #2 so don't forget to click on "all" or you will see only reponses #5-14.Snowmann's reponse has the info you need..

Marc

Thanks for your  help, I am going to purchase an authentic Ariens belt in the next few days and checking the alignment of the pullys.

Thanks again

Brian

>>>The second belt was a belt from a parts store.

Auto belts at a parts place are made different than OPE belts you would get at a hardware store.  The OPE belts have a strengthened backing for OPE use.  Hardware stores often carry a couple of types of different quality in common sizes.   I have never had a problem with the lower cost belts and occasionally use the more expensive belts both of which are less expensive than a manf's belt.    One Murray belt was $42 which was $9 at the hardware store. 

Get the part number of your belt at the Ariens site and google it.  You'll get hits for various belt places and many list the size.  All belts I get for Ariens machines are hardware store belts and work fine.

I buy all my belts at Advanced Auto.  They sell a line of OPE belts. They are pretty heavy duty and I've never had a problem with them.  They usually run about. $9.50 each.

I relaced the belt with a OEM belt, seem to be about 1 inch shorter and much beefier than the last belt. All pullys are aligned and everything seems normal. After this winter is over, I will measure this belt with the old one I took out to see if it is stretched. Thanks again for the help.

Brian

Check  your auger drive for binding. Also check your idle pully for binding. Both should turn free by hand. Make sure you are adjusting it correctly. If you idle pully bolt is loose your belt will go out of adjustment

I had the same problem and I came to the conclusion that the engine is just so powerful that when the auger gets full of snow instead of the engine slowing down it keeps turning full speed and slightly slips on the belt and burns it.

Check if you have some black soot under the belt cover and around the inside. Also a belt that is all cracked up inside is overheating.

I have all the OEM sizes Ariens belts on my site at   http://www.c-equipment.com/snowblower-ariens-belts.html

Partsman, your a running advertisement not a contributor. Dennis, what are the rules on advertisers? Are we going to have to read ads in all posts?