Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I live in Calgary - we get a moderate amount of snow, rarely more than 8 to 10inches at a time, usually in the 2-4" range. The issue here is snow drifts.  I live in a north facing house at the south end of a cul de sac and get drifts all the time on the bottom half of driveway.  My driveway is for a 3car garage - not super long (probably 25ft, but easily 40 ft wide. I have been reading lots about single stage throwers - i like the fact they clean to the pavement, but am concerned if they can throw the snow far enough or can chew through a foot deep snow drifts a few times a year.  The other option of course is the 2 stage throwers - they seem a bit big and I've read they don't get down to the pavement. I am also not the  most mechanically inclined individual in the world...

Help?? Any thoughts on what my best bets would be?  I need something that my wife would be comfortalbe using as well. Any comments are appreciated...

gdoll - a good single stage will be perfect for your application.  It will throw the snow fine and will go through a foot deep drift with zero issues.  Look at the Toro 221 or 421 models.

I'm not sure what type of singles you guys have been using, but I'm in MA as well, and we've had/used GOOD single stages my whole life, and never had any issues.  And I don't live down on the south shore where snow is minimal either - I'm much closer to worcester.  Lived on a cul-de-sac for 23 years - never had a problem (or a maintenance issue either).  Always had at least a 6 car driveway as well.

Sure, I have a big two-stage as well, but in 3 years I've used it twice, both times simply because I wanted to, not because I needed to. 

The talk about "muscling" a single stage around is also a bit confusing.  All the one's I've used (Toros and Hondas) have been as simple to operate as a vacuum cleaner - a mostly one-handed affair as well.  The Two-Stage, on the other hand, is a slow, plodding, "muscling" type effort - and when I need to go to work in the morning, walking along at 0.7 mph behind a 300lb piece of equipment is a waste of time.  My single stage can be moved around quickly, dragged backwards with one hand, spun around, tipped, lifted, pirouetted, whatever, with zero effort and with speed.

gdoll wrote:
You have a 40 feet wide driveway at the end of a cul de sac?  I can see the plow guys can have lots of fun after taking a sweep around the cul de sac pushing all that snow and then dumping in front of your driveway.  That is a very wide end of drive pile to tackle.  I didn't realize your driveway situation until I read your post again.  Around here, even if we have 3 car wide driveway, it tapers down to 1 1/3 wide at the driveway apron.  Of course, in your situation, you can choose to clear enough snow so that a car can pass through, not necessarily all 40 foot of it.

Based on what you said about getting a few foot high drifts a year, and typical snowfall of 2-4" at a time, and Calgary 53" annual snowfall, I would still recommend a modern single stage snowblower.  You can start your snowblower in the middle, and the snowblower can toss snow at least 20 foot to either side of the driveway.

I would go for a small 2 stage like a Ariens Compact 22. It comes with a very good Subaru engine and can handle a lot more snow than any single stage. Thay aren't that exspensive eather.  Most single stage units are 2 stroke engines.You have to mix oil with gas. You also have a rubber paddle to adjust time to time and or replace for ware. A  2 stage you will not have any of those problems. A  2 stage can handle end of day snow too. They are very easy to work on .  All you need to do is keep your oil changed, and keep FRESH gas in your tank. Most of us use Stabil in with our gas to keep it fresh. From time to time you may pick up a rock or something and brake a SHEER pin. A sheer pin is a pin designed to sheer off to keep you from damaging any thing. They too are easy to replace and are good to have a few on hand just in case. Keep it well greased and you are good fo more than 10 - 15 years service. I have a Ariens 924 that is 12 years old and never let me down.

I would have to lean towards a 2 stage as well. The EOD garbage that I deal with is tough for a 2 stage let alone a single. I realize you can chop it up a bit with a shovel but even that can be a task sometimes. I guess the best of both worlds would be one of each! Money being tight these days however, would push me towards a small 2 stage like the previous poster stated - a nice compact 22" or 24".

The reference to muscling the single stage would be the effort required to get through the EOD mess. A 2 stage will simply work it's way though a heap of compacted snow, where the single stage typically requires a lot of pushing and pulling while slowly taking small bites out of a pile. Not being self propelled means you are physically pushing it into and through deeper drifts and piles. While I agree that a single stage is a perfect partner for smaller snowfalls as they are typically very light and maneuverable.

Keep in mind I have never used a more modern higher powered single stage and like I said, my previous neighbor before I moved had plenty of luck only using his toro single stage but for the heavy snow that we tend to get in New England on the coast of MA I am better served with a smaller 2 stage. FYI I picked up the compact 22 referred to above with the subaru engine. While I haven't had a chance to try it out, I wouldn't think that it would cost much more than a better single stage. $699 at the HD, and it seems like a quality machine. Hopefully this is confirmed when I get it out in the snow.

FrankMA wrote:
I agree with FrankMA.  I have both a single stage and 2 stage snowblower, as well as various shovels and ice chippers.  Depending on the snow or temperature, you pick the tool best for the job.  My single stage gets 75% of the work around sidewalks, paver walkways, and near the house or flower beds.   The 2 stage takes care of end of drive and sidewalk intersections, as well as helping out neighbors.

If you must have just one and EOD is a big issue, get a compact 22-24" 2 stage.  They have metal auger to break down hard EOD, and that is their only advantage over a single stage, IMO.   I would venture to say that a 22" compact 2 stage with 200cc engine is unlikely to have more throughput than a 21" single from Toro or Honda.  21" singles have better efficiency.  Their auger/paddle drivetrain is lighter and simplier and no self propel to sap power that should be going to the auger..

Thanks for all the advice.  I went for the 24" 2-stage...ended up buying a Craftsman/MD with a 249cc B/S engine, 11.5 lbs of torque. Wish me luck!

Good Luck!

superbuick wrote:

Here in Upper NH they use Honda and Toro at the colleges for clearing the walks for the students. They do not use singles stage blowers that I have seen or heard of. Single stages are limited and up here when you might get 12+ inches of snow a single stage won't cut it. They are good for places where you get a lot less snow.

I'm in northeastern MA on the NH border and I don't see many single stage machines around these parts. I think if you have small areas to contend with or if working a 2 stage is a problem then a single would be the best way to go. For a property owner with a substantial amount of snow clearing needs, a 2 stage is really the most practical way to get the job done. I'm not trying to start a single vs. 2 stage war - just stating that a single stage would not be the tool of choice for most of the storms in this area.