Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I just swapped a 3-year-old Toro 1128 OXE for an Ariens 1332LE (924128)...because I wanted/needed a larger machine.  Can anyone date this Ariens?  It appears to have very little usage (scraper blade is almost unmarked, chute has just a few marks).  The Toro is a great machine, but I really need the extra size. 

Well???  Did I just blow it????   Go ahead, I can take it...

There's quite a bit of paint gone from the bottom of the impeller housing.  This may be normal
or you may have a worn impeller bearing allowing the impeller to rub on the housing.  You can
easily check the bearing by seeing if you can move the impeller at all with your hand (with the
machine turned off).  There should be no play at all.

Paul

Any snow thrower that will be moving end of driveway deposits will have the paint removed from the impeller housing in one season or less.  Gravel, salt and dense snow make an abrasive and corrosive concoction.   Check your own machines.  I had a look at my one year old machine yesterday and there's not much paint to be found inside the impeller housing.

While we're on the subject... is there a consensus on the necessity of getting in the impeller housing with a wire brush/sandpaper and touch-up paint? I did that last year and it was a pain. And of course, much of that work from last year is already worn off by this year's record snowfall here in SE Wisconsin.

mfduffy wrote:

Waste of time and effort.  We'll never keep up with it.  When wear causes excessive clearance, put in a Clarence kit and go for another ten years.....

mfduffy wrote:
I can't disagree with Borat on this, it's just too much trouble - and almost impossible without pulling the impeller.  I just spray mine with some CLP*, even my MTD RustMagnet(TM) holds up well with just that.

*Break-Free CLP, meant for firearms: Clean-Lubricate-Protect. Available at sporting goods stores and even some Walmarts. I stopped using WD40.

Link: http://www.break-free.com/products/products_breakfreeclp.asp?catalog=industrial

trouts2 wrote:
Actually this model is from 2004. Keep the belt adjusted and you'll be fine. A 32" bucket and 13hp engine  with a 14" impeller will be rougher on belts than the Toro due to the increased volumetric capacity (this model does not have an available dual belt drive). Also, this model (and most 924,XXX models preceding it) are known to be on the fast side in first gear. 5 minutes and a metal lathe could possibly slow this down if needed. The 13hp Tecumseh engine is a real treat as it is the only counterbalanced snow engine. Smooth as glass.


PK

Snowmann:

Have you heard of any reliability issues with the 13 h.p. ohv Tecumseh?  I looked at a used Ariens 1336 and the engine had very obvious evidence of being apart either several times or worked on by a sloppy mechanic.  That's the main reason I passed up buying it.  After reading several other posts about the  problems with the 1336, I'm  sure that was the right decision.   

Snowmann wrote:
Could you please elaborate ?  My 9526DLE is also too fast in first gear.  What can be
turned, the engine pulley ?

Paul

borat wrote:
Nothing excessive or unusual. A few throttles that would loosen and not hold a few years back. A good engine for sure.

PK

pvrp wrote:
Yeah.

Did you try to adjust the shift rod trunion ? Not sure about the 926,XXX models, but on the multi-speed Compacts you can adjust the trunion 4 turns or so to slow the unit before wheel torque becomes a problem.

PK