willatki
Joined: Feb 24, 2006
Points: 2
![]()
|
 |
replacing auger blade on Sears snowthrower
Original Message Feb 24, 2006 2:06 pm |
|
Greetings, All!
I have an 11 hp ohv Sears Craftsman snowthrowerand I have to replace the rh auger blade which is on a sleeve fitting over a shaft.
I am trying to bring the entire auger assembly out of the housing to get clearance to remove the blade, but the shaft from the impeller will not come loose (although I've taken out the bolts holding the impeller to the shaft and it just spins, so that's not holding it)...
so... the question: do I have to split the machine and go in from the drive side?
and... what is the function of that roll pin?
and, most of all, is there a quicker way to do this, ideally before the next snowfall brings us to 5 feet on the ground? ; )
Bill near North Bay Ontario
|
