Vacuum Cleaners Discussions

Is it TTI or still Panasonic?

OMG!!!!

I didn't want to start a new thread so I just kept this one going since it's pertaining to the Kenmore Can.......Mine is about 3 and a half years old..........I buy those envirocare synthetic cloth bags........

Yesterday I went to change the bag, opened the bin and the bag had COMPLETELY slipped off the collar............It was a mess..........This has happened to me three or four times in the past and I have been SOOO careful when putting them on....... I had to get the Rainbow out to clean the inside of the Kenmore..........

After cleaning, I changed all three filters. Hepa, Chamber, and Bag.........I can't for the life of me figure out how these bags continue to slip off........I thought the first couple of times it was my fault because I didn't have them very secure or something, but this last time I was so careful in that it was on properly..........I'm the only one that uses this machine and it hasn't been turned over or anything to cause the bag to slip off......

You should have SEEN the inside of the bin.

Is there anything I can use to keep this from happening? I put some packaging tape on it in such a way that I think it will stay, but I don't know if anyone has a better method.

mark40511 wrote:

More like "Houston, we have a problem."  I highlighted parts of your message that are significant for diganosis and response.

Your last question first:  Stop using the Envirocare bags.  Convert to Ultracare bags.

Question 1:  Is this condition limited to this one package or have you had several packages of these same Envirocare bags do the same thing: slip off the bag holder?

Question 2:  Is the bag collar plastic or cardboard?

Question 3:  Have you gotten all/most of the dirt that bypassed the bag and pre-motor filter out of the motor compartment?

Carmine D.

Here are the bags I use, and if they don't slip of the collar, they are FABULOUS.....No loss of suction as the bag fills, and no trace of dirt/dust in the bin

The collar is cardboard, but the odd thing is that it's a really SNUG fit

This is not limited to this package. This has happened with other packages in the past as well. I think it's happened to me like three times

The motor safety chamber filter HOPEFULLY protected the motor since that was obviously the ONLY thing keeping the dirt from getting sucked right into the motor. The motor still sounds fine.


To be honest, I can't remember but I think this has also happened with the DVC microlined paper bags one time on me as well.....I could be wrong on that. I have used those in the past as well.

As it is now, when I put the new envirocare bag on, I taped it and then tried to slip it off the collar and it won't come off unless I take the tape off or pull really hard, so hopefully that will help........


http://www.totalvac.com/A137.html

Question 3:  Have you gotten all/most of the dirt that bypassed the bag and pre-motor filter out of the motor compartment?


Forgot to answer this

I don't know HOW I would get any dirt that bypassed the chamber filter since I don't know how to take a vacuum apart.

mark40511 wrote:

Short of taking apart and cleaning, I suggest:  With a new bag installed, pre-motor filter in place, remove the post motor, or exhaust filter.  With vacuum running, stop the suction opening by cupping your hand over it.  Remove your hand and continue repeating the hand blocking procedure.  Note if and how much dirt is coming out of the exhaust opening of the vacuum.  If dirt is doing so, continue running, using your hand to block the suction opening and unblock the opening until all/most of the dirt emitted from the exhaust subsides. 

Carmine D. 

Of course it goes without saying that the above procedure for clearing the motor compartment dirt is done outdoors. 

WRT terminology, the bag collar is the cardboard/plastic part of the bag that slips on and locks into the vacuum's bag holder.  If the collar is coming off [the bag not the bag holder] then the the problem is a defective bag.  Usually the glue holding the collar on the bag is stale, insuffient, and won't hold.  If the bag collar is slipping off/out of the bag holder, as is your case, the bag is not made securely enough to be used in your vacuum, without modification.  Hence, I recommend using the Ultracare brand of bags in your case.  But it's up to you.

Carmine D.

Carmine

The cardboard collar that is PART of the bag itself did NOT come off the bag. That's not defective at all. When changing the bag in the Kenmore can you slip the bag collar over the piece that accepts the bag. There is no "locking" but it feels like it's on there really good. When I opened the canister to change the bag, it was as if someone had just taken the vacuum bag and just placed it in the bag compartment WITHOUT even putting it on the canisters bag slider thingy or whatever its called. But I'm the only one that uses this vacuum and am very careful (especially since this has happened in the past) to put it on very securely. Though when sliding the bag onto the unit there really is NO locking that I can see, it just slides into place. It's very strange and I can't figure out how this has happened to me...........This last time I actually put mailing tape on the red thing that accepts the collar and the cardboard collar hoping that will keep it from sliding off. I even tugged the bag pretty hard and it's on there really good. So if it comes off this time, I give up. Now I'm paranoid every time I use it

This is a BLUE Kenmore from like three years ago. It's still a Panasonic.

mark40511 wrote: mark40511 wrote:

Mark, I figured all this out, more or less from our message exchanges.  The problem is not the vacuum but the Envirocare bags.  These are made to fit your Kenmore cann and are less expensive than the Ultracare brand bags, which are the original Kenmore brand bags for your vacuum and more expensive.  I have my own thoughts and feelings about replacement bags made to fit brands and models which I have expressed here on many occasions. 

There are a number of reasons this bag is not working:  The cardboard collar caves with use and as the bag fills with dirt.  Probaly not strong enough.  The cloth/paper bags should have a plastic collar which will not degrade with usage BUT these plastic collars are best served when they lock into the bag holder channel.  Can't with yours.  So, its a catch 22 with your vacuum if you continue to use the bags. 

Hopefully, you can get most of the dirt that by-passed the bag and pre-motor filter out of the motor compartment.  This shopuld give you another 2-3 years usage from this Kenmore cann.  Especially, if you don't use it that much and share the duties with your other vacuums. 

Carmine D.

CarmineD wrote: