Vacuum Cleaners Discussions |
|
Venson
Joined: Jul 23, 2007
Points: 1900
![]()
|
 |
Has anyone tried this???
Original Message Oct 27, 2009 10:19 pm |
|
There has been past mention that some of these "home brews" might not be the best thing for use with extraction carpet cleaners but I have been researching inexpensive AND "green" problem solvers for carpet cleaning. I'd like to know who has among us tried any of these methods and how they felt they compared to mass marketed or commercial cleaners and spot treatment compounds. Please review the following link: http://www.ehow.com/how_4719580_own-green-cleaning-carpet-shampoo.htmlThanks, Venson |
Vernon
Joined: Jan 21, 2008
Points: 69
![]()
|
 |
Re: Has anyone tried this???
Reply #17 Nov 3, 2009 11:24 am |
|
A product that I use that is environmentally friendly, works well, and is safe to use is called Procyon. Go to www.soapfreeprocyon.com The owner of the company, Mr Ivan Day, has had his product tested by leading carpet mills, green seal, and the carpet and rug institute, to name a few.
Initially you'll be a little shocked at using the product, as it does not produce foam/suds that we have become accustomed to, yet it does the job.
Venson, on dirty carpets, I will preteat with Procyon using my Lux shampooer, then rinse with the extractor. Depending on the area I'm in, ie hardwater/softwater, in softwater I'll rinse with straight water, if using hard water, I'll add about one ounce Procyon to 2.5 gallons water to rinse with, as the Procyon will help soften the water.
Vernon
|
Venson
Joined: Jul 23, 2007
Points: 1900
![]()
|
|
|
Re: Has anyone tried this???
Reply #18 Nov 3, 2009 1:58 pm |
|
. . . Venson, on dirty carpets, I will preteat with Procyon using my Lux shampooer, then rinse with the extractor. Depending on the area I'm in, ie hardwater/softwater, in softwater I'll rinse with straight water, if using hard water, I'll add about one ounce Procyon to 2.5 gallons water to rinse with, as the Procyon will help soften the water.<BR><BR>Vernon
Thanks Vernon. Venson
|
Just
Joined: Nov 28, 2007
Points: 172
![]()
|
|
|
Re: Has anyone tried this???
Reply #19 Nov 3, 2009 3:38 pm |
|
Just, The carpet man recommending you neutralize the alkalinity of the detergent may be steering you wrong. To clean carpets that are man made the ph is 9.0 and higher, wool is 8.5-8.0 any lower and you won't clean. Cleaning solutions run from 0-14 in ph. 7 being neutral(water). If you have a stain that you know has ph of 5 you need to use a spotter with 9ph or higher to neutralize it. If you don't know what you are doing you could keep the stain in your carpet forever. Urine for instance is an alkaline at first, let it set up after six months it turns to acid and burns into your carpet and you can't remove it. No commercial or diy stain remover will get it out then. Low ph is on the acid side of scale. Hair shampoo you use is low ph Acid side. Procare
Procare,
The white vinegar is used as a rinse after the cleaner has done it's job. The premise is some dirt is alkali and some are acidic, So you need to go both directions in the cleaning process to remove the dirt. This process did remove the browning I was experiencing in the high traffic areas. This is a Anso plush carpet BTW.
|
|
|
