Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hello, new to this site. I'm starting on a garage project to convert my tracked atv into a snow blowing machine. I picked up a Bolens single stage 38" snow blower off of Craig's list. It has a horizontal shaft drive coming off of it which turns a gear/chain mechanism on the augers, I assume the Bolens lawn tractor had a front pto this connected to. I think the speed of that pto shaft he thought was 2000 rpms. My plan, weld up a frame, or beef up the one on the blower to mount a horizontal shaft small engine behind the blower and mount that onto the tracked atv. Then a boom of some sort to raise and lower with the winch. I may need to add some weight support wheels, not sure on that, and I may want to wing it out 6-8" on each side to get beyond the tracks. I can get a 13 hp engine from harbor freight, will that be enough? For connecting someone suggested a direct connection through a lovejoy connector, since the drive shaft on the blower is a 3/4" square tube and not a "key" I'll have to fabricate something. Pros-cons with this setup, one I can think of is when the engine is on, this thing is spinning, fast. No clutch or brake to it, but it's simple. Anyone have similar contraptions? How much hp did you find you need? For a single stage blower like that, does the original factory rpms from the bolens the best speed for it to perform the best, or does it work better, throw farther, if it's spinning faster? Or is it optimal for the bearings on the auger/chain, and spinning faster puts those in jeopardy. thanks for your comments