Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I recently picked up a like new four year old Ariens 926LE with around 15 - 20 hours on it. I then used it about three hours this season. As I was finishing up the EOD snow last week the auger stopped working. I checked the belt ans it was so loose that adjustments didn't help. Just got done putting a new belt on it and compared the old one with the new one. The old belt, that was originial to the machine, was stretched out over 1/2 inch more than the new replacement. The new belt was the correctly sized replacement part. Twenty some hours of belt life seems short to me. Just curious what other folks are getting. 10 to 14 inches coming tomorrow in SE Pennsylvnia. It's been a good year for blowing snow.

iLikeOrange wrote:

I had to use oval hole and mounted it as close as I could to the belt. There was old belt residue so maybe there is an alignment that needs to be done.

u half to consider the machines age aswell.. 4-5 years old.. and u don't know how nice the owner was on it before u got it... from my experience 4-5 years is about right for a belt replacement... does it have an hour meter on it?..

If the old belt was never properly tightened then it could have been slipping every time it was used which would make it wear quickly.

niper99 wrote:

No hour meter on this machine. That would be helpful especially on a snowblower. Last year winter was so mild so I put zero hours on my blowers. This winter is a different story.

Shryp wrote:

I think that was the problem Shryp. Snowmann once told me about a dual belt kit for my Ariens 11528LE. Jacks Small engine carried it back then, part number 72600700. Wonder if that same kit can be installed on my 926LE...it's a model 926101 Serial 003318.

Paul7, it's a fact that the Ariens OEM auger belts last many times the life of aftermarket. Belts made after early 2011 are especially good (that would include OEM service belts for your machine). Trust me on this. I would never use aftermarket auger belts on this machine (Aramid/Kevlar belts are not all equal). Also, for a bit more than the cost of a replacement OEM single belt, you can get the dual belt upgrade complete with 2 belts, pulleys, etc. That would be on my Xmas list if I owned your machine. If you do have a new belt on the machine, regardless of origin, make sure you go through the run-in process and readjust the idler.

Thanks Snowmann. I will take your advice. Will the dual belt set up work on my my 926LE...model 926101 Serial 003318.

Yup. Part number 72600700