Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

This unit is NEW used it for about 2 1/2 Hr. Two times while in 1st gear going along it chattered for about 3-4 sec, Then it moved along fine.

Then while I was at the end of the drive w/ 8-10" of snow in 1st gear it stoped moving, The wheel's were not spining it just stoped moving.

I put it to rev. It moved in Rev great, then back to 1st & it went along fine till it did it again.I did the same move Rev went backwards then it was fine again.

I spoke with my dealer he said O just a cable adj. I will send someone to your house to adj it. Well when I got home it was gone. they took it in to make repairs. Just wondering if anyone had this happen to them.

My Dealer seems great he has been in bussiness for a long time My first buy from them, so far GREAT SERVICE.

Brent

ps excuse the caps.  i look at the key board and not the screen. 

I’ll look at mine tonight. If I remember correctly, that flat piece is snapped back by the spring to hold the right hand cam in place. This keeps the right handle down when the left handle is down and you take your hand off the right handle.

I'll also see if I can get a measurement in regards to the location of the notched piece under the dash so that you can compare it with yours.

Thanx.

Solara,

That piece with the gear shift notches also holds the cams. I measured from the back edge of the dash to the back outside surface of that piece and it is 13/4". I think if that piece is welded too far forward, that in addition to making it difficult to shift into the 6th gear notch, it would also pose a problem with the flat metal piece with the gold spring catching onto the cam and holding the right side handle down. This could be the problem with your machine.

Jonathan

 All,

Another Ariens QC problem ! ! !

                                                        Fred   

Don't know yet , Fred, but If he gets a bigger measurement I think that the welder's jig likely slipped. Jonathan

Thanx jonathan. will measure tomorrow.

solara wrote:

That was my thought also when you said it only worked with a fast slap when running, My guess was you were getting a lil more clearance (help) due to the vibration.  No I am not 100 percent it all happens under the dash.  when I looked last year I was pretty sure it worked all on it's own,  can't see why they would tie it into anything else..  Will try an look this weekend Just not easy to get to now. being we were gonna get long stretch of warm weather, i put it in a shed,  then had to temp store some furniture in front of it.  I have another SB in my garage.   sry picked the wrong one to bury.  or I would have given it a thorough look for u by now.

Ben07

brent, did u get your machine back? all ok?

Jonathan/ben. 

ok his is the problem .  when the rt handle is squeezed the cam tuns up and the tongue(?) is supposed to fit under the cam.  ( the  engaged tongue should holds the cam up and the handle down.). it misses by maybe 1/16 of an  inch.   jonathan u confirm hat there is only 1 spring holding (pulling) the tongue forward.   I could  grind the cam down a little or grind a little off of the tongue.  the pivot bolt that holds the tongue does not seem to have aby adjustment to it.

measuements  are tough to compare due to nomenclature.  i think that jonathan's measurement of 1 3/4 is 1 7/8 on mine