Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Toro 826OXE first oil change questions
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
rubinew
Joined: Dec 30, 2010
Points: 147
|
|
Re: Toro 826OXE first oil change questions
Reply #1 Jan 2, 2011 2:14 pm |
|
I would have to assume I already have 5 hours and being its 50 degrees outside, I figure its a great time. When I bought the machine I had the dealer put in B&Stratton 5w30 synthetic oil but it was the last one. Called around to a few places but seems nobondy has it in stock. Do I buy it online or can I use Mobil 1 synthetic 5w30 in its place. My plan was to stick with one oil for the life of the motor. My second question is does this motor have a filter, I would say not. Just trying to make sure. Is there anything else I should do after the first 5 hours?
hmmmm, First I will state, I am no expert on motors.
That said, I have a friend who has worked in engine repair for many years. When I purchased a new Generator, I was going to put synthetic oil in it, he flat out said not to, it was a bad idea to use synthetic oil in the beginning. His claim was that the motor would not 'Lap' in correctly, and seat the rings ect. as well. He did say that after puting some hours on, with a good oil, then I could change it up to synthetic if i like. But overall, he recommended just using a good quality oil, and increase the frequency of oil changes. Thought I would share!!
|
borat
Joined: Nov 10, 2007
Points: 2692
|
|
Re: Toro 826OXE first oil change questions
Reply #2 Jan 2, 2011 2:14 pm |
|
There's no need to run synthetic oil in a snow thrower. There's no advantage to it. You pay twice as much, if not more for the oil but do not get the advantages that a synthetic oil is designed to provide. That is, extended oil change intervals. You should change your oil every year so why waste synthetic? In addition to the above, my Simplicity snow blower has a 305cc B&S Kool Bore engine on it. After initial break in with conventional oil, I switched to Mobil 1 5W30 and that's all I ran it for three years. My engine consumed it at approximately one oz. per hour of use and the spark plug looked awful after the first couple seasons. See pic below. This year I switched to Castrol 5W30 High Mileage oil to see if it would reduce oil consumption. Although my machine hasn't seen the extreme hard use it did in previous years, it does not appear to be consuming this oil. I suggest you buy any decent quality, name brand conventional 5W30 or 10W30 and go with that. You'll have all the protection you need at a fraction of the cost.
This message was modified Jan 3, 2011 by borat
|
Spartan
Joined: Sep 19, 2010
Points: 14
|
|
Re: Toro 826OXE first oil change questions
Reply #9 Jan 3, 2011 4:48 am |
|
I'm really not sure what the image of the nasty looking spark plug is supposed to represent. If you are/were using synthetic oil and your spark plug looks like that, there are clearly other engine/maintenance issues going on. In any event, there are other advantages to using synthetic oil besides extended oil change intervals...even though most synthetic oil manufacturers will tell you to follow the OEM guidelines on when to change the oil. Aside from a few niche brands like Amsoil or Royal Purple, most synthetic oils on the market don't really push the idea of extended oil change intervals. Even though these are only basic/small engines....You're dealing with machines that are really only subjected to extreme conditions, the coldest temps of the year...an advantage synthetic oil has over dino oil. Especially when starting a cold engine. Also, these are engines that typically have no filter, with the additives synthetics have, your engine is better protected. The fact is, a quart of a quality full synthetic oil will cost you some where between ~ $7 - $9. Is that more expensive than dino oil...absolutely? But what's the point of penny pinching on machines that people are spending $1000, $1500, $2000, $2500+ etc on? Sure I'll buy an $1800 snow thrower but I won't waste an extra $3 or $4 dollars on a synthetic oil for it? That's ridiculous... imho I'm not implying you'll see a night and day difference between synthetic and conventional/dino oil...but there really is no advantage sticking with dino oil unless your intent is to save $3-$4 every which way you can. Unless the manual/OEMr explicitly says not to, you can't go wrong with synthetic...and change the oil when manual says to change the oil.
This message was modified Jan 3, 2011 by Spartan
|
|
|