Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I need to replace a muffler on a Briggs alum block and the old steel muffler is stuck on real tight. Is there a way to remove without damaging block ? Thanks.

Screw in or bolt on? -friiy

Post numbers of the model and type of the engine too... Friiy

Screw on pipe thread type muffler,engine Model no 190702, older 8hp horz. valve in block.

Did you loosen the star shaped jam-nut? -Friiy

Yes the lock nut is loose.

     Try heating the muffler pipe with a propane torch (not red hot)... See if the thermal diffrence/ expansion will break it free,   if that doesn't  try using some Kroll, PB  Blaster,  Mouse's Milk or some other type of penetrating oil on the threads,    reheat and try again after a few hours... ..

..........and use a  good pipe wrench.

Friiy

         Something I forgot....  take a punch around the pipe where it starts to enter the bock,   Tap the pipe with the punch  and hammer just enough to put a slight dent in the pipe close to the block... This will break the seal - "seal of rust/ corrosion"-- between the block and the pipe to help the oil get in.....

Good Luck,

Friiy