Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I have a 10hp 28" MTD model 660 2 stage blower w/ aTec Sno King motor. This unit has seen only two winters. The problems I'm experiencing is with the unit not throwing snow worth a dam ,until the auger and impeller has been running at least one pass up the drive (50 yards.) The motor runs strong and fine. The wheel engagement was sluggish yesterday as well. Could this be a simple case of needing to replace the belts. It would seem that once the belts warm up it works fine. Any and all comments are welcomed.

Last time my belt slipped was because I lost 10 pounds...

All I had to do was eat more to get 'er tightened back up !


Actually... I'm I kinda' skinny guy... so i got a new belt...


Dave...

the belt adjustment on this MTD is actually up by the handle bar.

you will notice a ferrule and a nut on the cable where it attaches to the lever.loosen the nut and then spin up the ferrule.

you may have to make a few adjustments to get it just right.

there is also the same adjustment for the friction disc.

just dont go to far or the belts will snap,2 3/8 for the impeller an 1 for the drive.

later chris

Chris- Your experience has truely been missed for a long time.  Glad to see you back!

Boston_Rob

On my Ariens it says I need to tip the unit apart between the frame and auger housing.

I wonder if Jubol's snowthrower is designed the same way?  If so Jubol, do you have any plans on changing that like you did your oil valve?  Would love to see picture of this process.