Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Ignition works, but it won't stay running

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
domake


Joined: Jul 5, 2010
Points: 1

Ignition works, but it won't stay running
Original Message   Jul 5, 2010 11:49 am
First time writing about mower, it is little hard to decribe the situation, but i will try.

I have dynamark 11/36(if it's correct name). First, battery ran out, so I hooked up w/ my alternative battery. Now, ignition sounds pretty good and all the drive chain starts rotate and even grass cutting knife works too(turns). Problem is it doesn't stay running. if I turn the key to the original position engine stops. any idea which parts i should be looking at to fix and what is the problem at least?

Replies: 1 - 1 of 1View as Outline
bus708


Location: Maryland
Joined: Jul 24, 2010
Points: 322

Re: Ignition works, but it won't stay running
Reply #1   Jul 29, 2010 11:31 pm
It sounds like your switch. Try hot wiring it. if it stays running it is your switch. if you have good spark and fuel it should run. check spark first. if good spark , get a spray bottle- put gas in it and spray in your carb.. if it runs wile spraying then something is wrong keeping you from getting gas. i assume the fuel you are using is fresh. don't flood it just give it a small shot. do not use eather.
Replies: 1 - 1 of 1View as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.