Location: https://t.me/pump_upp
Joined: Nov 16, 2008
Points: 264
Home made impeller kit Original Message Dec 3, 2008 10:21 pm
Since I had the auger assembly apart to replace bearings & bushings, I thought I would try my hand at fabbing an impeller kit. Already had all the materials laying around. I still have to put everything back together, but I can hardly wait till I can try it out. I used some 1/4 rubber sheet I had and hope it will last a while.
Don't know if will make any difference, but I thought it might be a good idea to bevel the leading edge to help shed the snow.
Re: Home made impeller kit Reply #23 Nov 20, 2009 9:40 pm
GtWtNorth wrote:
"The next morning, I was giddy with the prospect of taking a bit of stroll past his place. I waited until later in the day (gave lots of time for the kid's father to clear the driveway) then went for a walk. As I approached, I could see the tell tale signs of coloured paper spread over a fairly broad area. As I got closer, I noticed that the driveway was only half cleared and the snow thrower silently sitting in the driveway. I took a good look at it from the street and could see that it had a bundle of flyers jambed in the auger and impeller."
Borat, you're my hero, that's what I call divine retribution. Did you ever consider writing short stories?
Yeah. I tried it once. By the time they finished censoring the book, all that was left was the page numbers.
