Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > 11 hp briggs engine does not want to run, floods
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions
11 hp briggs engine does not want to run, floods Original Message Aug 23, 2009 9:37 pm
I have been working to get an leaf loader ready for fall clean up. The 11hp briggs and stratton engine starts briefly when choked and then dies. Gas runs out and drips below. It runs all of 3 seconds before it dies. I've tried starting it without the choke but no luck there. When I bought it a week ago the previous owner started it on the first pull. It has a good spark, fresh gas, a clean air filter. With the spark plug pulled I can see the spark. I've tried starting it at half throttle, full throttle and low throttle. No difference there. I took the bowl off the carburetor and cleaned out the crud that was in there. Do I need to take the carb off and completely clean it? What setting should the throttle be at for start up? Any suggestions? the motor is a Briggs Industrial Plus model 256422 type 1015 -E1
This message was modified Aug 23, 2009 by Underdog
Location: Las Vegas, The Desert
Joined: Apr 12, 2008
Points: 600
Re: 11 hp briggs engine does not want to run, floods Reply #42 Sep 24, 2009 7:49 pm
You can put a Ohm meter to the float assy and check to see if fails on the float or if the problem is in the switch. It could be a bad wire bumpign into something and grounding the unit out.. You could get a new gasket so next time you change oil you can pull the float out and wash it out in some gas.. (the oil alert/ Guard unit is encased in a tube and has holes that let oil in. sometimes muck or sludge hamper's its movement inside)
Just keep a good eye on your oil till you get it working...
Maybe now you can till the leaves into you garden..
You can put a Ohm meter to the float assy and check to see if fails on the float or if the problem is in the switch. It could be a bad wire bumpign into something and grounding the unit out.. You could get a new gasket so next time you change oil you can pull the float out and wash it out in some gas.. (the oil alert/ Guard unit is encased in a tube and has holes that let oil in. sometimes muck or sludge hamper's its movement inside) <BR><BR> Just keep a good eye on your oil till you get it working...<BR><BR> Maybe now you can till the leaves into you garden..<BR><BR><BR>Friiy<BR>
I never thought to try an ohm meter. I have one of those. So to check the switch I would disconnect the wire at the sensor's post on the outside of the engine block and then touch one lead from the meter to the post and one lead to the engine block? And if oil is full in the engine, the meter should show no continity, but if the oil sensor is showing "low" (or faulty in this case) I should detect continuity? Is that about right? ;And then if the oil sensor checks out OK then I should test the wire and see if it's grounding out someplace. <BR>Yes, you read my mind with the leaves being tilled into the garden.
This message was modified Sep 26, 2009 by Underdog
