Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > When I press the Primer bulb gas squirts on the floor.

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
Paul7


Joined: Mar 12, 2007
Points: 452

When I press the Primer bulb gas squirts on the floor.
Original Message   Jan 28, 2009 3:11 pm
I really like my Ariens 11528.  But my Tecumseh 11.5 HP OHV engine has been nothing but trouble.  It had to go in the shop right after I bought it almost 2 years ago because the recoil starter would pull halfway out and then snap back into the engine with a vengeance.   Got that fixed.  Now today It won't start.  When I press the primer bulb gas squirts out from under the engine and onto the floor.  Any ideas would be appreciated because even though it's still under warranty it will cost me $60 for the dealer to pick it up. 
Replies: 13 - 14 of 14Next page of topicsPreviousAllView as Outline
Paul7


Joined: Mar 12, 2007
Points: 452

Re: When I press the Primer bulb gas squirts on the floor.
Reply #13   Jan 31, 2009 4:09 pm
mml4 wrote:
He ran the tank dry but probably didn't drain the carburetor bowl. Varnish can't form in the carb if  fuel isn't present. I use stabilizer as well but have found it only delays the inevitable.

However,I fully admit to being more than a little obsessive when it comes to fuel .

Marc


Correct.  I asked the dealer how to prevent this going forward and he said to add a fuel stabilizer to the gas just leave gas in the tank over the off season.  In my area we have a 3 month snow season , Jan - March.  I'm not sure that a fuel stabilizer will prevent varnish for 9 months.  So now I'm definitely going to drain the carb bowl after I run it dry. 
mkrind


Joined: Dec 10, 2009
Points: 3

Re: When I press the Primer bulb gas squirts on the floor.
Reply #14   Dec 10, 2009 7:24 am
I had a backwards issue.  I am pressing the primer bulb and I am not getting ANY fuel to inject into the carb throat.  It sounds like air hissing back and forth.  I popped the carb off, float is loose, the needle looks good, w/o taking it out.  Nothing seems to be clogged yet the hissing comes from this port that I believe you all are talking about is where the excess gasoline escapes when over primed,  THis does not seem normal to me.  Is there a check of some kind that may be tarnished over or something?  Please let me know. Thanks.
Replies: 13 - 14 of 14Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.