Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > auger gear oil question

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
mikiewest


Joined: Dec 29, 2007
Points: 262

auger gear oil question
Original Message   Jan 25, 2009 5:22 pm
The manual just says to check it.How often should it be replaced?is it like the engine oil and be replaced after so many hrs of use or years??
Replies: 2 - 5 of 5Next page of topicsPreviousAllView as Outline
garysherck


Location: Cleveland, OH
Joined: Jan 23, 2009
Points: 9

Re: auger gear oil question
Reply #2   Jan 25, 2009 9:50 pm
If Ariens wanted us to change it, seems they would tell us. As you say, the manual says just to Check It.

For my 926DLE it says" gear cases are filled to the correct level at the factory. Unless there is evidence of leakage, no additional lubricant should be required. Check oil level each season or ever 25 hours of operation. ... then it goes on to tell you How To ensure adequate lubricant level ... and to use only Ariens special gear lubricant L-2.

Perhaps, after 75-100 hours, or two years, you might want to replace the lubricant, but if lubricant in automobile differentials last longer than the car, it may not be necessary.

gary
borat


Joined: Nov 10, 2007
Points: 2692

Re: auger gear oil question
Reply #3   Jan 25, 2009 11:34 pm
I ran two Craftsman machines for a total of twenty years and never replaced the gear lube.  I inspected it annually to ensure it had sufficient lubricant and that it looked "normal" but never changed it.   Not saying you should do the same but I believe that if the lube isn't being contaminated and isn't leaking out, It should be fine.  Running in a snow thrower gear case isn't  as stressful  as in the rear end of a vehicle.  Gear lube stands up for years, at high speeds, heavy loads and hot temperatures in automobiles.  In a snow thrower, working at much slower speeds, lower loads and cooler temperatures, it should last for many years if it doesn't leak or get contaminated. 

Mikie:  If you plan to change your gear lube, make sure you get the right stuff.  Not sure about your machine but mine requires the use of Benalene, which I'm finding hard to find in my area.  I still have to try some farm equipment/tractor repair shops to see if they carry it.  But, as per above, I don't really need it.  Would be good to have on hand if the occasion does arise.

mml4


Snow is good,
Deep snow is better!


Joined: Dec 31, 2003
Points: 544

Re: auger gear oil question
Reply #4   Jan 26, 2009 6:18 am
 Borat-Simplicity Winter Weight Gear Lube is Part# 1704636- That's the correct Benalene based lube. A guy on Ebay has it listed for about $17 usd for a quart. The web parts houses have it for $4 and change but don't tell you the size of the container. 

Marc

SnapperV210P,Toro22177,TroyBilt42010Snowthrower,Craftsman Shredder,American Turbo Pressure Washer HondaGX200,Stihl011Saw,EchoPas260Trimmer Edger,EchoPB602Blower,EchoHCR150Hedge Clipper
nibbler


Joined: Mar 5, 2004
Points: 751

Re: auger gear oil question
Reply #5   Jan 28, 2009 10:33 am
I had to have new lube in my van's differential because I backed it into a lake and water got in the differential. That was at about 220,000 Km.

I'd recommend changing the auger gear lube every 200,000 Km whether it needs it or not..
Replies: 2 - 5 of 5Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42