Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > general Blower question
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
Wheels
Location: Kingsville, MD
Joined: Jan 17, 2005
Points: 19
|
|
general Blower question
Original Message Feb 19, 2008 6:55 pm |
|
I have not posted here in a long time, but I have a question for you folks. Last winter was mild and I did not use my blower at all. Did not even put gas in (in case there was no need). Now this winter is almost over and I have not even gassed up the machine. So unless there is significant snow in the next few weeks, the machine will not have been run in two years. Should I just put it away again for another year, or would it be advantageous to gas it and run it for a little while til the gas tank is dry? What are your thoughts? Thanks.
This message was modified Feb 20, 2008 by Wheels
Ariens 8526LE, Cub Cadet 2185 LT, Troy Bilt 8hp 5550 Watt Generator
|
Snowbound
Joined: Feb 17, 2006
Points: 76
|
|
Re: general Blower question
Reply #9 Feb 22, 2008 12:23 pm |
|
Loading up the generator: I suggest not using a toaster if you plan to run the machine for awhile. This could be a possible fire hazard. Toasters are designed to run for very short periods only. Many irons today are designed to shut down automatically if left in an upright position for around five minutes or so (unless you have lots of ironing, take advantage of the moment and get your household ironing done). Also, a hair dryer would automatically shut down through a built-in circuit breaker to prevent overheating, after running several minutes of continuous operation. I would use an electric heater, or possibly two, to draw around 3,000 watts. Don't plug any appliance in for at least a few minutes to avoid an initial surge output by the generator. The surge could hurt your appliances. Be sure the electric heater(s) are away from anything combustable if outdoors. Large appliances, like a refridgerator, are a good source to draw a load, yet they are thermostatically controlled and will go on and off (mostly off) over a two hour period.
|
|
|