Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Ariens broke during second use - need help

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
newtonian


Location: Windsor CT
Joined: Dec 12, 2004
Points: 86

Ariens broke during second use - need help
Original Message   Jan 6, 2005 8:12 pm
Have an Ariens ST 8526LE which broke the second storm it was used in.

Was wonderful to use the first time. Second storm was about 4" snow followed by rain - real heavy stuff.

Don't know if the chute was clogging from the slushy snow and it then broke, or if it broke first and then clogged as I moved forward. The impeller is stuck and there's nothing apparent holding it. The augers rotate on the shaft about 1/8", the belt is intact and engages when the handlebar lever is pressed. It smoked a bit from under the belt cover when this problem first occoured. The shaft as seen under the black plastic belt cover does not turn where it leaves the belt pulley area. I cannot rotate the augers when it's parked (and of course, off).

It's a chore+ to get this to the dealer. His only words of wisdom were to bring it in. Any help on what to look for would be appreciated.


2012 Ariens ST24DLE
Semi Retired Ariens 9526 in active reserve
Unknown vintage 5HP Ariens to restore

Replies: 3 - 8 of 8Next page of topicsPreviousAllView as Outline
Dave___in___CT


Deliberate often...
...decide once...


Location: West-Central Connecticut
Joined: Sep 17, 2002
Points: 3159

Re: Ariens broke during second use - need help
Reply #3   Jan 7, 2005 7:01 pm
newtonian gave his update at the other forum... (WTB)

Cause was a loose belt...

Fixed...


Dave...


Whether you think you can or you can't... you're right.
Henry Ford

   BCS Tractor & snowblower

newtonian


Location: Windsor CT
Joined: Dec 12, 2004
Points: 86

Re: Ariens broke during second use - fixed!
Reply #4   Jan 7, 2005 8:35 pm
Problem was my own fault. I thought I'd do the 15 minute break in belt adjustment at the first oil change - ha.

The belt was simply loose, very loose. I had to remount the idler pulley on the innermost mounting hole to create tension on the belt. I didn't check the belt tension earlier (hot engine), just saw that the idler was engaging.

Never expected it to be so far off with so little use. Even mounted on the innermost hole, when the machine is off and the handle lever is pressed, it appears not to be especially snug; there's about an inch of free play on it's long run side. Is that normal?

Thanks for the support.... and I'll get some extra belts to have on hand.


2012 Ariens ST24DLE
Semi Retired Ariens 9526 in active reserve
Unknown vintage 5HP Ariens to restore

Snowmann


Joined: Dec 3, 2003
Points: 494

Re: Ariens broke during second use - need help
Reply #5   Jan 7, 2005 9:03 pm
Newtonian,

Did you try adjusting the auger cable first? The owners manual states to tighten the auger cable until it is taught, then loosen the adjustment barrel two turns and tighten the jam nut. This must be done first. If the belt tension is still loose (make sure the back side of the belt is pulled -perfectly- straight, away from the backside belt fingers), then switch the idler to the second position and readjust the cable with the same procedure. It's important that it's done in that order.

PK

This message was modified Jan 7, 2005 by Snowmann
navihawk


Joined: Jan 17, 2003
Points: 1318

Re: Ariens broke during second use - need help
Reply #6   Jan 7, 2005 9:31 pm
Sounds like you smoked a belt. you should tighten the pully after a few hours break in.With the machine off,when you engage the auger,the belt might feel loose due to the tension pulley being spring loaded.Not sure about Ariens but the tensioner pully has a pin that you pull out so you can take the belt off.I would replace the belt.Read the manual.It will guide you through it.
This message was modified Jan 7, 2005 by navihawk
faithfulFrank


He is no fool who gives up what he cannot keep
to gain what he cannot lose....


Location: Batavia, N.Y.
Joined: Jan 20, 2004
Points: 1067

Re: Ariens broke during second use - need help
Reply #7   Jan 8, 2005 8:34 am
Great to see snowmann over here!
Welcome Paul!!

Frank D.

Ariens 1332DLE Pro, Exmark 52" HP ZTR, Gardian Generac generator, Shindiawa T230  Excell/Honda PW, Craftsman rototiller, Favorite IPE- My Mac + Ipod- No Windoze for me!
Emmo


Joined: May 22, 2003
Points: 1065

Re: Ariens broke during second use - need help
Reply #8   Jan 8, 2005 3:19 pm
Great to see snowmann over here!
Welcome Paul!!

Frank D.

Yes Welcome Paul, thanks for your continues input. It's very valuable!!
Replies: 3 - 8 of 8Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42