Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

This is my first post and hopefully my last stop.  I just bought a snowblower, a Ariens ST 1032 / 10 HP 4 Cycle.  I don't know to much about adjustments on the carb.  The elevation I live at is 9,200 Feet above sea level.  When I started the snowblower up at the buyers house ."6,000 Feet, it was fine."  I got to my cabin and started it up and it sounded like it was bogging down after running it for a bit.  Through internet searching I have found that the carb has two adjustments?  One spring screw under neath and one on the side.  I don't know which dose which or where to start.  I think I have screwed with it a little to much and would like to know how I can set both back to a netural spot and start over.  Please help as I have lot's of snow to blow....

Thanks

Ryan K

Go to Lowes, buy a piece of steel, 2 in's wide x 4 feet long and 1/8th thick.

Cut in half, grind corners round, drill holes to match auger housing sides.

Then paint and install with carrige bolts and wing nuts!!

Cost about $10.00!!!

                                                       Fred

Thanks for the specs ... I'll get this done this weekend..

Thanks Again,

Polish

I also painted 2 tennis $#%* Day Glo  Orange, cut slits in them and put them over the tips.

Did it just for safety reasons, did not want to fall on a dull spear!!

                                                             Fred