Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > My old toro puked up oil.....?
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
faithfulFrank
He is no fool who gives up what he cannot keep to gain what he cannot lose....
Location: Batavia, N.Y.
Joined: Jan 20, 2004
Points: 1067
|
|
My old toro puked up oil.....?
Original Message Jul 1, 2005 3:08 pm |
|
Hey Guys, I have an old, but mint looking 1987 front wheel drive Toro push mower, model 16775. It is a 21" mower that has I believe the original 3.5 hp engine on it. It seems to burn a bit of oil, so I always keep a close watch on it, adding some almost every time I use it........(30 wt is a cheap fix) I checked it today before I used it, and the oil was just above the full line. I just use this to trim around trees, etc. Today while mowing, I noticed it started making a faint tapping noise, not loud, but enough to be a bit concerned. When I was done trimming, I let it cool down, then tipped it on the opposite side of the spark plug, as I have done in the past. This time, oil started comming out of where the air cleaner is. I set it back down, cleaned up the now soaked foam thing and the plastic thing the foam sits in, and rechecked the oil level. To my suprise, the oil level is now much higher then before. I'll let it settle some more. Question is, do I have anything to be concerned about? I know that this is not concidered a high end mower, but I do like the front wheel drive for trimming around trees. The deck is new looking, although I wish the engine was a bit more powerful. Should I start thinking about getting another mower?? Frank D.
Ariens 1332DLE Pro, Exmark 52" HP ZTR, Gardian Generac generator, Shindiawa T230 Excell/Honda PW, Craftsman rototiller, Favorite IPE- My Mac + Ipod- No Windoze for me!
|
faithfulFrank
He is no fool who gives up what he cannot keep to gain what he cannot lose....
Location: Batavia, N.Y.
Joined: Jan 20, 2004
Points: 1067
|
|
Re: My old toro puked up oil.....?
Reply #16 Jul 9, 2005 10:31 pm |
|
Dan, Maybe you're right, but I think I'll fiddle with it awhile longer, while keeping an eye open for a replacement. We finally got some much needed rain yesterday, so I know it will be time again to mow in the next day or two...... i'll try out the mower again and report the results. The oil is back to the normal correct level, I think it was just goofy for awhile because of the tipping. i'll listen again for the tapping. If it continues to work, I will then perhaps ask you all about doing that valve and ring job thing.... A friend of mine has a mower that has a bad deck, maybe I should check on swapping engines....although I think mine has a pully above the blade to run the front wheel drive, so they may not be compatable..........I'd have to look. I do not think it is worth putting too much money into it. I do wish the engine was a bit more powerful then 3.5 hp. The deck still looks brand new, and I do like the mower a lot, so maybe it is worth taking apart and learning something. Maybe the whole mower will just blow up the next time I use it, and I'll have to get a different one......although I always thought that if i was good at keeping oil in the thing, it would never go bad on me....... In any event, I depend on you guys to educate me.......i'll keep you posted. Frank D.
Ariens 1332DLE Pro, Exmark 52" HP ZTR, Gardian Generac generator, Shindiawa T230 Excell/Honda PW, Craftsman rototiller, Favorite IPE- My Mac + Ipod- No Windoze for me!
|
|
|