I am trying to clean the terminals within the wiring harness connector that plugs into the ignition switch.   It seems like if you put the screwdriver in the right place they should be free.  Has anyone had any luck with how to do this, and have directions and tips for me? 

AJace, you might a good contact cleaner. Maybe someone else can a better way.

Super Contact Cleaner

Contact Cleaner

I like the felt tip cleaning idea.  It's moreless rust not too much corrosion. 

if they're the round pin type terminals a .17 or .22 cal cleaning brush will work on the female terminals, a small piece of scotchbrite pad will do the males of either round pins or the flat spade type.......female spade type are tough to clean.....best ive found is a thin piece of metal say from a soda can, and fold a piece of emery paper over it to clean inside the terminal. then blow out gently with low presure compressed air

Great Idea.  I got crossed eyed trying to look into the connector to see if there is someway to take them out.  I gave up.    I'll use both suggestions though. 

I use my Dremel tool with the small, circular wire brush. Cleans off ALL the crud promptly...

Marty

If I remember you did that to your JD that gave you a rough time starting.  I was awaiting your response on this thread eagerly.  I have the Black & Decker version of the rotatory tool.  Dremel has some nice cleaning attachments, I never knew existed.   What number do you use?  Did you cut any of the plastic on the connection doing this?   

AJ - I should have been more precise in my posting. I used a Dremel #403 on the ignition switch's male terminals that are actually ON the switch itself. For the connector's inside cleaning (female terminals), I use thin, modelling files (from my model building days) to get inside to polish them up.

Marty

Just trying to figure it out. 

My Sears YT16 was sold UNTIL it's starter wouldn't spin today. Guy came today to pick it up - figures. He wasn't happy, but I mentioned that this could have happened AFTER he brought it home! So after some quick diagnosis, I too, have a similar ignition switch contact problem. "Dremel'ed" the switch contacts, filed the connector contacts, but I get no voltage to the solenoid. Worked on it in the rain, so I wasn't 100% thourough. Wire to solenoid from ign switch has good continuity. Have 12v at the "B" terminal. I jumped "B" to "S" (solenoid) at the connector & it still doesn't spin over. I either have a broken wire or completely corroded terminal INSIDE the plastic connector. Guess I'll have to use crimp, spade type lugs to repair this...

Marty

I guess you don't have 12v coming to the starter wire (where is connects to the starter terminal).   If not it's electrical, if so then the start is either faulty or it needs better ground.