Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

When i was cleaning my mower the other day after cutting. I tilted it to the wrong side. I was unaware of any problems. Then i noticed there was oil leaking out of the air cleaner. I removed the air cleaner and noticed there was alot of oil in there. I cleaned it out and replaced the air cleaner. I have not started the mower yet cause i was worried that i might have done some damage to the engine. By the way the mower is a craftsman with a 5.5 honda engine. If you need the numbers to help me out i can get them. Don't have them available right now. Thanks for any imput you can give me.

Here is a pic of the engine. if this helps

PC82,
I don't know.
Some people on some earlier posts recommended taking the spark plug out, and pulling the engine over a few times, with the plug out,  ignition off. Just to make sure there is not much oil in the  cylinder. Any further precautions to ensure that there is not a good bit of oil hidden in the intake system somewhere, I don't know. You might want to make sure the air cleaner is not too soaked.

just be sure to  top the motor off with oil if necessary. pull the plug out and clean or replace if necessary, & pull the starter rope through a few times to blow any excess oil out of the cylinder. you may have to clean the plug a couple of times if theres alot of oil contamination in the cylinder & it'll probably smoke for a little while, but there should be no engine damage

Also spray the carb down with gum out or some equivalent  cleaner.

You shouldn't have problem with the advice from this board.

General rule of thumb - spark plug up.  We see lots of mowers come into the shop with the same thing done.  We repalce the filter and get them up and running again.  They usually smoke for a little, but that's good for fly control.

Sherri

Papercut-82----That  happens to all of us in our career of mowing.  I try  to always lean the mower on it,s side so the carburetor will be up and it never happens then.  The carb. is attached to the side of the engine where the valves are mounted.   Evidently the intake valve was open so it let  the oil come into the carb. Don,t how on the overhead valve engines.  My theory may not work on them.  I have never owned a push mower with overhead valves.---Wish you best and we will talk later---Will

I have done this myself a few times but usually all it takes is a new sparkplug and air filter and your good to go.

Thanks for all the advice. I am having a hard time finding a spark plug for the mower. The part number is NGK BPR6ES. I am going to check the auto parts stor to see if they can help. I did find that chanpion makes a plug equivalent which is the RN9YC. Should i go with the champion or fidn the other plug. I don't know if it will make a difference but it could. I can fidn it online but don't want to wait for it.

papercut82 wrote:
The Champion equivalent will work just fine.

I agree, most small engines use Champian plugs anyway

Well guys you were all right. I did as suggested by you guys and then mower runs fine. Thanks alot