Forum - Print Page

Forum
/cgi-bin/yabb/YaBB.pl
General >> Vacuum Cleaner Forum >> Seeking a Air Turbine Floor Brush
/cgi-bin/yabb/YaBB.pl?num=1175564797

Message started by george on 04/02/07 at 9:46pm

Title: Seeking a Air Turbine Floor Brush
Post by george on 04/02/07 at 9:46pm

I was wondering if someone in the forum can direct/or supply a Air Turbine Floor Brush. I have searched the internet and Ebay and can not seem to find one.

The vacuum I have now is a Pro-Team CX400 canister and would need a brush to fit 35mm wands. I see that the 32m from Wessel Werk is available but not for the European models.

Any suggestions would be appreciated.

Thank you,

George

Title: Re: Seeking a Air Turbine Floor Brush
Post by Mike_W. on 04/02/07 at 11:59pm

Your Proteam uses the same European 35mm as the CX440, so check out the website below.

http://www.factorydirectsuperstore.com/ProTeam/CX440.htm

Your vacuum cleaner can also accept a power nozzle kit.

What you may want to do to save some money is to search around for a standard sized 1.25" fitting turbo nozzle and also purchase an adaptor tube that converts 35mm to 1.25"(32mm). These can be found in most vac shops and online.

Wessel-Werk is the main supplier for the turbo brush rug attachment. You can find the attachment most anywhere. If you get this w/32mm fitting, you can also use it on future machines w/the standard fitting.

Title: Re: Seeking a Air Turbine Floor Brush
Post by george on 04/03/07 at 8:52pm

Thank you Mike for the information.

George