Vacuum Cleaners Discussions

I purchased a used Dyson DC17. BAD IDEA It was so full of pet dander, and my friends are allergic to cats, that i was afraid to turn it on. Since i am handy, i completely took it apart, cleaned everything that can be cleaned very well. ALL the caked on white dander, and poop is gone. I know. poop. I should have known better i guess. 2 questions: - Does all the dirt pass through the motor? I didnt clean the motor as it was not easy to open or get to. If dirt does through it, is it possible that it is filthy like the rest or it? I know other vacuums had dirt go through it, but the dyson is like 100,000 rpm and i feel like it would shatter if a penny went through it. - is there a local store that sells the grey extension hose near seattle? that is impossible to clean 100%. Thank you! Sam

Hello Givemesam:

Out of curiosity, I did some research to determine what motor is used in dyson's DC17 and decided to post it here:

thank you! ill look into that!

DC 17's are faulty machines. They have a seal in the bin that doesn't work properly. Dirt gets in every pore of that machine. I think there is a warranty/replacement out on some parts.

Lucky1 wrote:

Hi Lucky1:

I didn't know this about DC17's.  But I began to suspect a problem when all the big box retailers culled it from their shelves and rumors spread that dyson planned to scrub the model from its line up.

Carmine D.

Those motors are very tolerant of abuse. I have a couple of canister vacuums that use that motor which were severely neglected (one was free, the other $20 on Craigslist). The motors were filled with dirt, in one case so much dirt you could not even see the fields or commutator. It looked like the motor in a floor brush with hair and dirt poking out of every opening, yet it still ran fine. I cleaned them out with compressed air, pulled the carbon brushes and found they were almost full length but the housings were packed with dirt. Blew the dirt out of the brush housings too. Once clean the fields, brushes and commutators on both motors looked unworn. Smooth bearings and no noise. In short, if that motor is in your vacuum and it sounds good don't worry about it. If you really want to knock yourself out have fun removing and cleaning it. It will outlast the rest of the machine.