Vacuum Cleaners Discussions

Carmine,

This will probably fall under your area of expertise and experience, but all are welcome to contribute. As I transition from being unemployed to being self-employed, I am looking for more specialized services to offer my clients.

There are specialized 'rug dusters' for sale which tap the accumulated dirt, dust, sand, and grit out of Oriental rugs by laying them face down over a grid which gives the debris room to fall. These cost upwards of 4,000.00! These have been developed as an alternative to the huge stationary 240 volt dusting machines. All of this to replace regular vacuuming with a Hoover 300, 700, or 150, the ones with the dual divergent agitator bars, with shorter agitator bars and bristle strips in between on each side.

The magic of the Hoover was that the 5,000 taps per minute during slow motion vacuuming set up a wave pattern that  vibrated the rug, dislodging the dirt, sand, and grit. It was not accomplished with tremendous suction, though the airflow was good, it was the balance of enough suction to keep snapping the rug up after each tap. The sand was not actually beaten out of the rug as much as the rug was pushed down leaving the sand in mid-air to be caught by the airflow generated by the fan, as explained by the laws of Newtonian physics.

My question is this: Short of finding and restoring a few 150 Hoovers, is there any alternative? Would any later model Hoovers accept the dual divergent agitator? How late? A current Guardsman, maybe, with some alteration perhaps?

A Kirby with a cloth bag has been suggested to me. A G series will not accept a full-fledged sani-emptor, and probably is too powerful to sustain the tap/snap action. A cloth bag would yield too much airflow, and a hepa bag too little as it fills. A Heritage I with a cloth bag seems the only other possibility. The Sanitaire Vibra-Groomer I is not sufficient, about the same as the standard Hoover agitator with just one strip of beater bar per side.

The idea of being able to restore neglected Oriental rugs with simple thorough vacuuming for good pay is very appealing. As I understand it, Hoover abandoned this configuration of agitator because as area rugs gave way to wal to wall carpet, it did not grab and hold the wall-to-wall carpet as well as the newer, less expensive to produce version, which had just the one spiral strip per side. Hoover could have ruled if they had stuck to being a status symbol. Imagine being able to switch out the roller and bottom plate to adapt the vacuum to whatever carpet/rug/floor needed to be cleaned. The mind boggles, while the Hoover just beats, as it sweeps, as it cleans...

Trebor

Hey guys,

Adamant xxx that I am about some things -- and ready to stand toe to toe with just about anybody if I feel I'm right -- isn't some of this stuff, especially if it's going to get personal, better served by PMing each other? Nothing is being helped.

You all have tremendous talents and perceptions plus loads of personal experience that have served many of us well. Continued jibes and obligatory retorts regarding issues that are, were and still will be debatable are clouding the view of all that.

Best,

Venson

Trebor wrote:

Hi Trebor:

You'll recall for many many years that all HOOVER vacuums carried the inscription:  "HOOVER makes rugs last longer."  Which all the major rug makers wholeheartedly agreed with.

Carmine D. 

Venson wrote:

Hi Venson:

I'd put you on the short list of the gentlemen and scholars who post here.  And high atop the list.

Carmine D.

Model2 wrote:

Before I opened my business, I was a professional vacuum rebuilder for the trade.  My rebuilts, sold for new door-to-door, by salemen with larceny in their hearts, who couldn't make the $deal for their own brand.  Of course wheh I learned this, I opted of the arrangement and went into business.

WRT the old HOOVER models, like you pictured, all the accoutrements like the name plates and even rivets [in black] were available from HOOVER and generic parts suppliers for rebuilders like me.  And were for many many years.  Never skimped on these small details because they gave the vacuums that like new look, despite their age and previous use.  Scuff marks, even deep, were no match for my high powered buffing wheel, fabricated from an old washing machine motor, and assorted rouges and of course my attention to detail.

Carmine D.

Model2 wrote:

Touching story.  But I'd never let her touch one of my rebuilt bags.  A stitch in time saves nine is fine for socks and stuff not cloth vacuum bags.  I used a heavy duty sewing machine, surplus sale from the military, for repairs and refurbs on cloth bags.  Worked like a charm.  I was the first to add colored leather cuffs to the frail and faulty bags spots for reinforcement.  Lasted years.  Added a nice flare and fancy too.  When the HOOVER branch office in East Orange NJ, just a stone's throw down the road from my store location in Bloomfield, learned about it, it farmed its bags out to me for repair.  Not all customers could spring for a new bag.  But a repair job, that was better than new, by all means.

Carmine D.

Model2 wrote:

What is "worthy of being called an expert?"  There are alot of people with their own unique skills, knowledge and abilities in and around the vacuum industry past and present.   They're called "experts."  Are they "craftsmen."  "Experts" may/may not be.  A craftsman takes an old, beat up, junked up vacuum out of the rubble and turns it back into the pretty and perfect specimen it was back it's it day.  Regardless of its current age and past use.  That's what some of the independent vacuum store owners/operators do who post here.  That's one of the things, I did.

Carmine D.

Model2 wrote:

Excellent series, "I Spy."  Bill Cosby was wonderful.  But right now I'm thinking more "Get Smart."  Did you get that one on BBC?  Do you recall the introductory clause:  "Would you believe............."  It comes to mind now.  But not in the same farcical way, in fact just the opposite.  I'm proud to say that thanks to me and a handful of other US citizens, Aldrich Ames, the most notorious traitor and spy in the annals of CIA history, was put permanently behind bars.

Surely, when I get to Heaven my friends and family, BOSS HOOVER included, who could not thank me in their lifetime, will do so in the next.

Carmine D.

Model2 wrote:
CarmineD wrote:
God whispers inventions into mans ears so to better life.  If TTI were good stewards (growth via honest means and building better mousetraps) God would be pleased.  The Book describes in no- uncertain terms how He loathes thieving, lying, unfair gain, etc.  God calls men like this evil.  TTI’s greatest attributes are... taking ideas from others (stealing) and selling them cheaper than those who birthed them.  As well, they are by definition... a monopoly.

DIB

*Some called it intuition or a feeling or a [flash of genius] eureka moment.

Below is an example of Knock-off manufacturing's work...

MIELE must surely be flattered by the resemblance.   Thanks for posting the comparative pics.  MOLE was the first, if I recall correctly, to point out the similarities of these two brand models and others.  It was on a thread here that deals, among other issues, with the evolution of today's vacuums into standard looks and features without unique variances.

Carmine D.

CarmineD wrote:
Applauding thieves?  Chapter and verse please (support in scripture).       DIB