Abby's Guide to Vacuum Cleaners
Username Password
Home Discussions Reviews More Guides
Abby’s Guide > Vacuum Cleaners > Discussions > problem with my Sanitaire SC887

Vacuum Cleaners Discussions

Search For:
Vacuumfreeeke


Joined: May 9, 2008
Points: 105

problem with my Sanitaire SC887
Original Message   Dec 30, 2008 10:29 am
Hey guys... wondering if you all have any suggestions about a problem I discovered in my Sanitaire SC887 this morning.  I just reassembled the bag/bin compartment after washing it and went to use the machine this morning.  Well, it was about 3 times as loud as it should be and the bag BARELY inflated.  It did, but not firmly and I was able to "squish" it easily with my hands where as before that wasn't possible.  I turned the machine over while running and the it seemed to be running at full speed.  The fan didn't have any broken blades from what I could see without digging into the machine.  When I first got the machine, I took it to the shop to get the height adjust knob replaced and the guy said it needed new bearings too so he replaced them.  It's beein fine for 3 years, but this morning, it's having a serious issue.  Any clues as to what could be going on with this thing?  My ears actually hurt after trying to use it for 5 minutes!
Replies: 6 - 12 of 12Next page of topicsPreviousAllView as Outline
Vacuumfreeeke


Joined: May 9, 2008
Points: 105

Re: problem with my Sanitaire SC887
Reply #6   Jan 4, 2009 11:17 am
Thanks for the advice.  I tried to move the fan around and it is tight and none of the blades are broken.  Someone suggested that since I washed the bag and none of the pores are clogged yet, this may be the issue... not sure what else to check! 
mole


.

Location: earth
Joined: Sep 30, 2007
Points: 783

Re: problem with my Sanitaire SC887
Reply #7   Jan 4, 2009 3:23 pm
Hey V.F. did you install the  F.G. paper bag right, remember the thin part of the bag where it attaches to the bellows thats the part with the spring on it. The big part of the bag goes to the outside where the zipper is, the bag should say top and bottom and looking at you when you unzip the outer bag. I have seen many people install the bag wrong and have the chute on the wrong side and in upside down blocking off the airmovement, is the machine really revving high more than usual?

Is the bag blowing up like nomal?Did you lock the sole plate in right? Did you install the belt right? eurekas go a quarter turn to the left, Hoovers goes to the right.on the open fanned machines.Does your 887 have the qiuck kleen clear [fan case]? there  is a seal that goes on the scroll, real thin gasket,

If you want send me the machine and i'll fix it for free. It should take no more than 15 mineuts...........

MOLE

CarmineD


Joined: Dec 31, 2007
Points: 5894

Re: problem with my Sanitaire SC887
Reply #8   Jan 5, 2009 7:59 am
Hello Bobby:

Washing a cloth upright bag like the EUREKA would result in your symptoms: Run louder and with less suction.  The cloth bag muffles the noise and allows peak suction by letting out enough air to keep the motor cool and prevent overheating.   When washed, then the water opens the bag pores.  This degrades two of the bag's functions:  Muffle sound and produce peak suction.  Never use water on cloth bags, especially upright bags. 

Carmine D.

This message was modified Jan 5, 2009 by CarmineD
Vacuumfreeeke


Joined: May 9, 2008
Points: 105

Re: problem with my Sanitaire SC887
Reply #9   Jan 5, 2009 11:40 am
Mole, thanks.  My SC887 (all SC887s unless they have been converted) uses the dust cup as the bottom of a cloth bag.  It's messy and dusty, but I rather like seeing what it got up each time because it is a powerful machine. 

Carmine... How funny!  I thought it would be better... I figured clogged pores on a bag are a bad thing and that they actually impede performance.  Guess I'll "spill" some baby powder on the floor and go have a ball at it! 

Funny thing though... I was using it the other day and the brush roll actually STALLED when I got to my medium pile area rug.  I changed the belt which had stretched a little bit as it was about a year old, and I STILL had to raise the height adjustment a notch to make it not stall.  I thought these machines were more powerful than that!

By the way... I have a question that doesn't have anything to do with this post... if I I am looking at a Eureka/Sanitaire belt and a Hoover Convertible belt and neither of them are labeled, what's the difference?  Which one is for which machine?

Thanks
Vacuumfreeeke


Joined: May 9, 2008
Points: 105

Re: problem with my Sanitaire SC887
Reply #10   Jan 5, 2009 11:43 am
By the way... mine is supposed to have the quick clean fan casing, but when the guy replaced the bearings he said I needed a new one and he didn't have another in stock so now it has a regular casing.
CarmineD


Joined: Dec 31, 2007
Points: 5894

Re: problem with my Sanitaire SC887
Reply #11   Jan 5, 2009 5:52 pm
Vacuumfreeeke wrote:
By the way... I have a question that doesn't have anything to do with this post... if I I am looking at a Eureka/Sanitaire belt and a Hoover Convertible belt and neither of them are labeled, what's the difference?  Which one is for which machine?

Thanks



Hi Bobby:

Clogged cloth bag pores prevent sufficient air from passing through the bag to keep the motor cool.  But when cleaning the cloth, vacuuming and brushing the cloth are the best methods to keep the pores open, breathing and at peak operation.  The bag pores are small enough to keep all the dust and dirt inside, maintain peak suction, and allow air passage for cooling the motor.

WRT your question, if both belts are new, the EUREKA will be slightly larger in diameter and thinner.  This gives it more elasticity than the HOOVER belt because it has a longer reach than the Convertible.  In a pinch, both belts can be used for the same machine.  But I would not recommend doing so for the best performance and well-being of the vacuums.

Carmine D.

This message was modified Jan 5, 2009 by CarmineD
CarmineD


Joined: Dec 31, 2007
Points: 5894

Re: problem with my Sanitaire SC887
Reply #12   Jan 7, 2009 8:38 am
Vacuumfreeeke wrote:
By the way... mine is supposed to have the quick clean fan casing, but when the guy replaced the bearings he said I needed a new one and he didn't have another in stock so now it has a regular casing.



Hi Bobby:

Sorry I didn't see this and respond sooner.  The quick clean casing is a liner that fits on the vacuum's fan/motor housing that comes off and on easily during disassembly.  It allows quick and easy cleaning of the dirt path.  Hence its name.

Carmine D.

Replies: 6 - 12 of 12Next page of topicsPreviousAllView as Outline
Vacuum Cleaners Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.