Vacuum Cleaners Discussions

The solution for me is to change the whole main duct of the machine with a new one.  I have ordered this for £18 from Dyson spares.  I will have to remove the switch from the body,  has anyone here had experience of removing this switch I know that it requires a screwdriver at the side of the switch button to remove the switch but I am worried I might break this.

Sorry I am in the UK so that number will not work here LOL.  Dyson will charge a whopping amount to get this fixed and I feel I could buy a new cleaner for the price they charge,  I am more than happy to take it apart to fiz it shame I have to though cos I hate fidling with products that still work,  the motor, clutch vital parts still work perfectly just the stupid crack that has caused this issue for me.

Here you go bucks03 -- 0800 954 0154 -- this number is from the site in the UK. -- looks like ours except for the zero up front.  ( http://www.dyson.co.uk/support/ )  The pictoral guide MrApollinax supplied seems pretty straightforward but if you need further help maybe you can find it there.

Dumb question but regarding the crack do you think something like Super Glue or Krazy Glue would help once you get the switch fixed? I tried it on a broken plastic piece that activated the on switch for a PC we had here at the office and it lasted several years until the computer died.

Best,

Venson

Have you tried calling Dyson UK to check what they would charge?   I had the main body that houses the bin abd hose on my DC01 replaced in the past and they charged a standard £55.  Not sure if that is still the case, I think if it is a motor then of course it would be more.

DC18

I tried SUPER GLUE for plastic from my local hardware B & Q store but this did not work and I also applied gaffer tape and held the back of the machine when pushing and pulling on high resistant flooring but eventually this gave way and the handle just kept coming out cos the crack just opended upand would not hold the handle in.

I have already ordered a 'duct' from Dyson and this is supposed to be here and ordered a switch button and switch button holder from www.partmaster.co.uk they have all the parts for Dysons in UK.  Dysons own catalogue does not list these parts.  I think I will have to use this site again for my AEG LAVAMAT 72640 FL washing machine has the  drum hit the glass door and marked it when spinning a load of towels.  Anywway sorry I'm going off topic!

I will attempt to change the parts over to the new housing when the part arrives and hopefully my machine will be up and running.

Hi DC18

I think the price is more than £55.  Its charged at £65 fixed tariff.   I don't feel the need to get Dyson to comeout to do this when the whole duct assembly is under 20 quid, I can fix myself.  I replaced the motor in my spare Dyson DC05 last year.

The only thing is now that my DC04 no longer has the Dyson Helpline sticker or the serial number sticker as these where attached to the existing part.  A lot saved then getting Dyson engineer out.

Bucks03:

If you access to a hand held hair dryer, you may be able to get the old serial number and hotline stickers off.  Using a medium to high hot setting, run the dryer over the stickers and slowly lift off a corner and continue heating and removing.  Be careful not to burn your fingers in the process.  Then use some new glue to replace the stickers on the new dyson housing.  Should work if you are patient.

Carmine D.

I will see if I can peel it off.  However at the end I will not be able to place on the new part as the adhesive part would have come off the sticker.  I'm not too bothered as the machine is way out of gaurantee now.