|
Re: Deere 826 ID and low tossing distance.
#1 Nov 9, 2011 6:56 pm |
|
I recently picked up an 826 from my Brother in Law. I have the front end disassembled and have decided to implement some of the changes discussed in this thread. I am going to purchase the auger kit. I have already done minor repairs to the auger where it was bent, probably from stones. I would like to look for a replacement pulley that is either a 2.5/3 or even a 2.5/3.5. Can anyone tell me the best way to find such an item. My experience in the past is that to get a part you really need a part number. I have picked up a couple of the auger bearings from JD and noticed they have changed a little. They are a little longer now and have a grease seal on them. maybe they will last a little longer.
|