PeteF

Googling around did not get a hit on those engines. You could try to locate a smashed model of the types Snowmann mentioned. I picked up two dead 932’s with perfect motors. Snowmann: On L-head rod freezes and rod breaks the cam usually survives without injury. I’ve never had one that was bad out of 8 broken engines. I’ve opened up one 11hp OHV with a rod break and the cam was fine. PeteF: In what way is the engine toast? Is it just frozen, rod break, or rod break and case cracked? All of those are possible to repair. When the rod freezes it’s because the rod and crank journal heated up so much the rod (aluminum) meltes and attaches to the steel crank journal. If it keeps trying to turn then it snaps. Worse it snaps and the broken rod flails around in there hitting things or worse blowing a hole in the case wall. If you want to try to fix it then post that and you’ll get help. For a frozen rod or a rod break only where there is no case break or damage inside the fix is fairly easy which is to clean the journal with acid and buy and stick in a new rod. As Snowmann mentioned you could try to get another motor like yours which does not have a PTO and install into it your cam and case cover. I’ve converted three L-head 8hp’s to PTO. It’s fairly simple and you don’t even have to remove the oil while doing it. An OHV would be similar. In fact, many Briggs drawings of PTO engines the drawings have two case covers and two cams, one set for PTO and the other non-PTO. Another option is get a used MTD 8hp. With some minor adjustments you’d have strapping snowblower again. This option would be the cheapest by far. Lots of MTD engines out there.