Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

What's the metal disk and foam thing that's on the underside of a Tecumseh gas cap designed to do?

Discovered on my first gas refill that the parts on mine fell into the gas tank.  Fished them out but don't see how they stay on the shaft -- perhaps a clip broke off I haven't retreived.

Will replace cap, but for now was just wondering what that stuff does......

I looked at the cap for my pretty new Toro 828lxe.  The first thing in there was a cone shaped rubber cup that slips over the round shaft of the cap. This rubber thing pulls off the shaft very easy.  underneath the rubber is the foam thing.  My Toro has never stalled, but that cap sure seems to tighten itself as I use the blower.  I need a glove on to loosen the cap.  Could it be that some parts are missing and the vacuum is pulling in on the cap too much?  I didn't see any kind of a disk in there unless it is uder the foam thing whick I never removed.

al ...

you have the new style cap,no problems reported yet with it.

later chris

Thanks Chris.

I have the 8526 LE Ariens and noticed the foam thing when I first used the blower and removed the cap.  Didnt find any metal ring or clip.  Emptied the tank and saw nothing inside.

However on the first use, it stalled twice and when I remove the cap (chekcing gas level) I saw the foam square (1/2 " sq) fell out.  Since then with the cap on and 3 more uses, with no problem.  I looked at the cap design and saw a rubber funner type that inside the cap and saw how it vents to the outside but so far no gas spilled.

Should I continue or buy a new cap?

Thanks,
Neil on Long Island

Neil wrote:

Hello fellow Long Islander,

Neil, I would purchase a new cap since they've been redesigned.  This way you won't have to be concerned about it coming apart and plugging up the fuel tank. 

Richie:

Hey there, I am in North Bellomre, how about you?

The foam part came off and the clip is not in the tank (must have fell off into the snow).  The current rubber part (that is funnel shape) in no way can fall apart or come loose .... Will this be cover under warranty? or just get  the damn new cover ?

Neil

Neil,

If your warranty is in force, then they'll give you a new one.  I'd call your dealer and explain it to him.  Perhaps it would suffice to grab your receipt and bring the old cap to him.  I'm in the Manhasset area myself. 

Yea I am going to do that ..... man no need for the blower we had what 3-4 inches , plus some back excercise with the good ole shovel eh?

Did you get a new gas cap?

Neil

Neil wrote: I didn't need one for mine, it already had the newer type.

Replaced the cap and it runs fine now.  It studdered and stalled just like described above without the complete cap.

I did meet a grumpy dealer.  Went in with the Home Depot snowblower receipt and numbers off the engine.  Thought he'd just replace it but he insisted I bring in the engine per terms of engine warranty.  Implication was that it's a lot of work for him to complete the paperwork so I should go through a lot of work as well.

Cap was inexpensive and not worth dealing with, but did not expect such a response from the local Ariens/Tecumseh dealer.