Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Cast Iron Cylinder Sleeves
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
mml4
 
Snow is good,
Deep snow is better!
Joined: Dec 31, 2003
Points: 544
![]()
|
 |
Cast Iron Cylinder Sleeves
Original Message Feb 18, 2005 2:23 pm |
|
What is the purpose of sleeving the bore of a new engine with cast iron? The ohv Snow King Tecumsehs still have the sleeve while according to my dealer the Briggs Snow Intek does not. I am aware of sleeving being used to keep in service engines that have been bored to the point that the cylinder walls are too thin. Again,why on a new engine? Marc
SnapperV210P,Toro22177,TroyBilt42010Snowthrower,Craftsman Shredder,American Turbo Pressure Washer HondaGX200,Stihl011Saw,EchoPas260Trimmer Edger,EchoPB602Blower,EchoHCR150Hedge Clipper
|
robmints
Joined: May 13, 2003
Points: 4691
![]()
|
 |
Re: Cast Iron Cylinder Sleeves
Reply #38 Feb 21, 2005 7:01 pm |
|
Hey Rob, That was Snowshoveler with the Info!! Are we all getting old?? Fred Fred, I'm young, smart, good looking, have a winning smile, good sense of humor, and rich. Oops, wrong forum. Chris who?
|
|
|
