iblackford
Joined: Dec 4, 2014
Points: 3
![]()
|
 |
15hp honda clone in place of 10hp Tecumseh
Original Message Dec 4, 2014 4:44 pm |
|
Hi All, I have a 32" Sears snowblower frame that used to have a 10hp tecumseh. I got it as the engine had thrown a rod. I purchased a 15hp honda clone that I would like to use in it's place. The nice thing about the clone is that the shaft size is identical, so I can just swap the pulleys over. However, the block mounting dimensions and the shaft height from base is larger on the new engine than the old. I could just start cutting, drilling, and hacking to get it to fit, but does anyone have experience with this swap before that could provide details on the correct method to adapt it to fit? Thanks, Ivan
|
