Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

So i picked up this CCR2000 a while back for $20 because the lower housing was badly rusted, but the everything else was usable. I replaced the lower housing & put on a new scraper bar.



Everything went together well, but it seems to be sitting pretty far off the ground (1/2 to 3/4"). Is this normal for an ss? When using, how far do you have to tip it so that the paddles contact the ground and pull it forward?

Thanks

borat wrote:
I'm with Borat on this one.  Check the paddles to see if they are too worn down. 

At first, it looks like the scraper bar is too far extended, but rubber paddles are not seen from the side view.  So I'm thinking the rubber paddles are really worn out. 

The paddles should be replaced at the same time with the scraper bar to ensure optimal operating, proper bucket/paddle gap for efficient snow throwing and minimal tipping forward.  It also helps propel the snowblower forward too.  When you use a new scraper with a worn out paddles, the metal side buckets is more likely to scrape  the pavement when you tip it forward. 

Also, as FrankMA mentioned, the scraper bar as a slotted hole that allows the scraper bar to be adjusted down as the paddles wear.   Make sure it is on the correct end of the slotted hole.

BTW, those CCR2000 with the Suzuki engines are something.  They are great bulletproof engines but getting parts for them can be quite expensive.  I wonder how well it can handle Boratfication.