Honda HS928 Wheel Drive Snow Blower

kultyper

Joined: Nov 26, 2012
Points: 2

Honda HS928 Wheel Drive Snow Blower - Wheel Question
Original Message Nov 26, 2012 3:46 pm

Hi. I have a Honda HS928 snow blower. About a month ago, one of the tires were over inflated, and part of the tire slipped off the wheel causing all the air to escape. I had tucked the tire back in by hand, but now, the tire doesnt seem to be keeping air in when using a bicycle pump to inflate. It seemed like the tire stuck to the metal rim with some sort of adhesive, but i wasnt sure. I live about 30 miles from the nearest repair shop. Is the wheel easy to remove? From what it looks like, its just a pin that holds the entire wheel in. I would like to bring the wheel and tire into the shop to have them fix it. Thanks.

MN_Runner

Location: St. Paul, Minnesota
Joined: Dec 5, 2010
Points: 622

Re: Honda HS928 Wheel Drive Snow Blower - Wheel Question
Reply #5 Nov 26, 2012 6:42 pm

FrankMA wrote:

I had that same issue when I owned my HS624WA. The fix to end all fixes is to install a tube inside the tire and you'll never have that problem again. Do both tires because they'll eventually give you trouble and usually not at an opportune time, like when you need to use the snowblower. Tilt the blower up using the bucket as the pivot point and then place wood blocks under the tranny housing. Remove both tires (rims and all) and bring them to a local shop that can install them for you, or you can try to do it yourself. I can't remember exactly what it cost me for both tires but it was pretty reasonable and saved me a bunch of time and aggravation. FWIW, I think I used to run my tires at about 8 - 10 PSI which provided a good amount of spongy traction.

FrankMA is correct. The only way to fix those damaged tires are by adding inner tubes. They are much cheaper than new tires. The new 2012/2013 928WA/WAS uses higher pressure tires so you can just bite the bullet and buy those or spend $20 and get inner tubes with your current tires. Just place something (wooden blocks) under the tranny housing and take the wheels off.

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions