Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Using a snow blower to power a generator?
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
GtWtNorth
https://t.me/pump_upp
Location: https://t.me/pump_upp
Joined: Nov 16, 2008
Points: 264
|
|
Using a snow blower to power a generator?
Original Message Nov 3, 2012 6:14 pm |
|
With all the crazy weather happening in the last 2 or 3 years I've been thinking about getting a 4000 to 6000 watt generator for emergency use. At the same time I was wondering about using a snow blower tractor unit to power it a la Ariens Trac Team. I would attach the generator to a shaft that went through a plate & had a pulley attached. There would be a couple of pieces of angle iron attached to the plate, configured so that when you wanted to use the generator, you just loosened the 4 bolts & split the snow blower, then connected the tractor section to the generator & tighten the 4 bolts. Thus way you get more use out of your blower (4 seasons). Call me crazy, but I was wondering if the blower engine would stand up to running for long periods to power the generator since most generators run at 3600 rpm??? Cheers
https://t.me/pump_upp
|
engie
Joined: Nov 4, 2012
Points: 1
|
|
Re: Using a snow blower to power a generator?
Reply #2 Nov 4, 2012 5:13 pm |
|
The engine would be fine running for long periods in the cold/winter. In fact, the engine usually lasts longer than the snowblower it's attached to.
The conversion to a "snow engine" makes engines ill-suited for summer duty. Removal of the air cleaner is the biggest concern here - The engine would be sucking in whatever dust/debris happens to get near the carburetor. On top of that, the heat box/trim on the engine might cause overheating...Snow engines usually have max temperature ratings on them for these reasons (That, and emissions requirements change for summer duty vs. winter duty).
It's a better idea to get a standalone generator.
|
GtWtNorth
https://t.me/pump_upp
Location: https://t.me/pump_upp
Joined: Nov 16, 2008
Points: 264
|
|
Re: Using a snow blower to power a generator?
Reply #3 Nov 5, 2012 7:37 am |
|
I knew about the tapered shaft, but I have seen some generator units (just the generator, no motor) for sale with a straight shaft. As far as winter & summer temps & air cleaners, I hadn't got that far yet, but it is a valid point. You could always hook up a foam air cleaner. Looks like I need to keep thinking about this, thanks for your inputs. Cheers
https://t.me/pump_upp
|
|
|