Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I have what I think is a tecumseh series 3 carb from an 8HP engine that I think is a model HM80? The carb started leaking after not being used for some time. I installed most of a rebuild kit which included a new needle and seat. I've read up on how to do this and I think I have done everthing right? The spring that attaches to the float has the pointed end pointing towards the choke. The seat has the groove facing the carb body. It still leaks like it did before the kit installation. When feeding fuel to the carb, with the bowl off, I can stop the flow of gas by gently pushing up on the float. The float has no fuel in it, I hear nothing when I shake it and it floats in water with no bubbles coming from it. It acts like the needle is not making contact with the seat to stop the flow of fuel? Any ideas?

Thanks

I would be happy to. It is quite simple with the vent blocked air can't enter or leave the bowl. As the gas flows into the bowl through the needle it tries to raise the float at some point the pressure of the gas & the float matches the pressure of the compressed air trapped in the bowl. Unfortunately this happens before the float rises high enough to close the needle. But there is still plenty of push left in the gas as the level of the gas is much higher than the carburetor so the gas is pushed up the emulsion tube into the throat of the carburetor.

AJ

Got it, thank you very much!

ajallen wrote: