Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Just thought that I would share how I wound up redesigning the chain tensioner on my Ariens 1028.  If some of you might recall at WTB, I was complaining how the chain tensioner would be "bent" away from the chain during heavy loading and thus would leave the chain slack during easy going.  This slack would cause the chain to bunch up and jamb at the lower gear to case location.  I wound up using an original Ariens hex shaft and modified it by having a larger diameter sleeve bushing welded onto the threaded end of the shaft.  After cutting to the proper length, I mounted it into a rigid flange bearing.  Careful locating and drilling of hole and SUCCESS!!

Here is the link to the photos of this modification, I hope it works.

http://img.photobucket.com/albums/v715/bbwb/Chaintensionercloseup.jpg

I believe that the original configuration that is on my machine is the same as the current ones....Maybe if PK takes this back to the company I might get a large royalty check so that I may retire???

Let me know what you guys think.

bbwb

What I found is that the taught side of the chain is as follows:

     Moving forward - opposite of the tensioner

     Reverse - same side as the tensioner

The bending force on the original tensioner would only occur while trying to back the machine out of hole etc...It was so great that the side case of blower would distort at the slotted hole.  My first repair was to add the larger fender washers to each side of the hex shaft.  That worked for awhile but would still be moved out of position thus not keeping any tension on the chain.  While rolling the blower around in the garage (not under its own power) I would hear a metallic clicky click.  What I found was that the chain, not being under any tension, would bunch up at the bottom sprocket and was contacting the bottom case cross member.  Twice the chain got caught and would not allow me to move it at all!!

To answer Johns question:

There certainly is some wobble in the drive sprocket and my new tensioner...from the factory welding of the sprocket onto the hex shaft.  My wobble is not radially but laterally.

bbwb

Jonathan

After reading your post about the radially off center gear reminded me of a message that I received from PK.  In the message he said that the hex shaft might have a weld filet binding on the chain or possibly some weld splatter.  Another thing to look for would be that the hex shaft if very straight.  Hope this helps.

bbwb

Great idea!  Nice design you've got there.