Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > How long to let enamel cure before assembling after repaint?

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
manjestic


Location: North Shore, MA
Joined: Oct 31, 2011
Points: 87

How long to let enamel cure before assembling after repaint?
Original Message   Nov 27, 2011 9:13 pm
I finished the last coat of paint today.  The can says 7 days to fully cure.  Should I wait until then to assemble my Sno-Thro?  Used Rust-Oleum Enamel.
This message was modified Nov 27, 2011 by manjestic
Replies: 11 - 12 of 12Next page of topicsPreviousAllView as Outline
manjestic


Location: North Shore, MA
Joined: Oct 31, 2011
Points: 87

Re: How long to let enamel cure before assembling after repaint?
Reply #11   Dec 1, 2011 4:43 pm
Thanks, Carlb.  Yes, I used Rust-Oleum Engine Enamel.  I do have some 2000 grit wet/dry paper.

I've been using denatured alcohol as a prep to remove oils and sanding residue...can this be an alternate for paint thinner?
carlb


Joined: Nov 16, 2010
Points: 279

Re: How long to let enamel cure before assembling after repaint?
Reply #12   Dec 1, 2011 5:13 pm
yes alcohol is fine
Replies: 11 - 12 of 12Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.