Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Trying to keep an old (1970?) Ariens 7hp in use.  It's going pretty well, except for the shifter.  In N it creeps forward and getting into R requires persuasion and more to have it engage.

The adjusting nut is loose, but I can't budge the adjusting barrel.  Tried PB spray and let it sit a few days, and then a propane torch, using a large vice grip and a 12" pipe wrench it wouldn't budge.

I can fudge the adjustment, I think, at the lever end.  But should I make the shaft longer or shorter, and by what measurement?

Or is there anything else I can do to make  it work?

Just to confirm, you're referring to the bicycle brake like lever that's released to engage the power, and squeezed to stop power transmission to the wheels? 

Yes, but usually you have to push the lever down to engage the drive.  When it is released or in the up position the blower stops.  Kind of a safety thing.  But maybe yours is different. 
It would help to know what model you have.  If you can still read the tag it should be on the back of the frame right below the engine. It should start with a Nine like 924XXX.

This is the old model, the lever is on the underside of the handlebar and has to be squeezed for the machine to stop and released for it to go.  Totally opposite of today's models, this one will run away if let go of.

So is it the same adjustment sequence?