Though you all might like to the see the Toro SS blower rack I made for transporting it around. Project # 1
(Hope I can remember how to post photos)
This unit also holds my Toro CR20E blower with the use of an extra bungee cord. Hooked around the
existing handle on the red strap. And then onto the lower lift handle on the CR20E.
The wheels get captured so it can't move up or down or backwards.
The latch for locking down the tilting bed was made from a commercial spring loaded hinge.
The hinge places a pin through the angle iron frame. And a piece of flat steel also slides over the
top of the angle iron frame. Both pieces keep the frame from tilting. Pushing down on the
yellow lever pulls both pieces away and the bed can tilt.
The strap holds the front of the blower down and also keeps the fold up gate tight against the front of
the blower so it can't move forward. Drilled a hole through the front of the blower and used a 3/8"
bolt with a fender washer on the back to create a pin to put the strap on.
It's actually much easier than I thought it might be to pull the blower up the ramp.
