Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

It was a problem getting the ring in because the bottom of the bore flares out.  You can't use a ring compressor.  I put the top of the piston in the bore then tried pushing the ring in with the tip of a pick.  In the process the ring broke.   What's the way to do it?

Where should the ring gap go?  Is it centered on the longest section of uninterrupted wall?

The crank weight has 11 degrees stamped on it.  How is the timing set?  I have not taken off the flywheel and assume it only goes in one way but not sure.  There is no key shown on the exploded view. 

   The ring came in and installed.  On screwing on the head the glued ear broke off.  The ear section contained half of a screw position.  I think the mate of the ear to the rest of the head ok but when screwing in the screw the ear broke.  It went in with resistance.  There was probably glue in the thread area and caused too much pressure on the ear.  The other head screws were put in and the section by the ear covered with glue along with a large section of head to crank.  Glue now runs from the head through what’s left of the screw hole over to the crank section.  The glue section then is massive and covers the head and crankcase area.

   It starts and runs so if the glue and the other screws hold the head in place it should be a viable engine.  I’ve got a trimmer with the same engine so will probably swap them and keep the original as a spare.  The engine had very low compression and now gets 120psi.   The purpose of messing with the engine was just to get experience with two strokes.