Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

what size pulley should iput on 305cc engine there is a 51/2'' pulley on blower .it is a 36' cut blower for a lawn mower but i am modifying to go on atv .its a single stage so i want to get most power i can out of it.any help would be appreciated thanks..

I had 4 stroke Honda 160cc engine running above 4000 RPM and it didn't feel right.  The noise was quite loud with the existing muffler.  The vibration was unbearable without some kind of isolation engine mounts from the chassis.

Increasing the RPM isn't really going to accomplish much.  On OPE engines an increase in RPM at the high end won't do anything to increase the torque. It fact it will probably drop, the higher you rev the
engine.  So the auger may spin faster, until you put a snow load on them. There is no short cut to take if your you don't have enough HP to run a blower.  And that is the problem you have. 
A 10HP engine simply isn't large enough to power a 36" blower. 

If there was a way around that problem with gearing someone would already be doing it.  Blower augers (single stage) and blower impellers
(2 stage)  need the right mixture of power and RPM to operate well.

There is no replacement for displacement when it comes to torque.

borat wrote:

Reminds me of an old hot rodder's saying "There's no substitute for cubic horsepower" :)

ok good to know for sure  tks for all the info you guys were a great help.