Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > New castviron gearbox for older 924050

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
kdez


Location: Ludlow, MA
Joined: Feb 4, 2009
Points: 45

New castviron gearbox for older 924050
Original Message   Feb 20, 2011 4:12 pm
I am installing a new gearbox o my Ariens 924050. I am replacing the original Aluminum box after close to 30 years. To my question ~ I cannot budge the fan (impeller) from the original worm shaft. A brand new o ne is under $100. Should i just install a new one and give up on getting the original of the shaft? I have tried pb blaster and a torch without luck. Ideas, suggestions?
Replies: 4 - 4 of 4Next page of topicsPreviousAllView as Outline
Bill_H


Location: Maine
Joined: Jan 12, 2008
Points: 354

Re: New castviron gearbox for older 924050
Reply #4   Feb 21, 2011 11:21 pm
Sure, but they all do. If you look at the MSDS for any of the commercial products, you'll see that penetrating oil is nothing but a light oil that has been mixed with a solvent which will help it penetrate. Acetone is a great solvent, and ATF is a high detergent oil. Machinists have been using this mixture for years.

BTW, reading the MSDS will also explain why WD-40 is not a good lubricant.

Who the hell let all the morning people run things?
Replies: 4 - 4 of 4Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42