Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Ariens 926PRO Electric Start Help
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
dcassell
Location: Boston
Joined: Feb 5, 2011
Points: 5
|
|
Ariens 926PRO Electric Start Help
Original Message Feb 5, 2011 11:07 am |
|
I have an Ariens 926PRO (model #926004) with 120v electric start which I use almost exclusively to start the machine. Today I went to start it up, and the electric starter sounds very sick, makes a much higher pitch squealing noise than usual and some other crunching type noises. Engine does not start. If I pull start, the engine starts fine. Unit was recently in the service position and I tightened up everything in the owners manual to spec with regards to controls and auger belt. Unit started by electric right after this, and that was 3-4 days ago. Now this. I have a youtube video of the problem here: http://www.youtube.com/watch?v=CFQtmSkE18cWhat am I looking at here? A bad starter motor? Does something else need fixing/adjustment? Help would be appreciated. I would like to try to repair this myself.
|
dcassell
Location: Boston
Joined: Feb 5, 2011
Points: 5
|
|
Re: Ariens 926PRO Electric Start Help
Reply #10 Feb 5, 2011 5:20 pm |
|
How do I properly inspect flywheel/ring gear? Sorry, my first time with this stuff.
For what it's worth, the "springy" action of the gear seems fine.. and if I manually put pressure on it and twist it seems to wind out the shaft with ease.
|
trouts2
Location: Marlboro MA
Joined: Dec 8, 2007
Points: 1328
|
|
Re: Ariens 926PRO Electric Start Help
Reply #12 Feb 5, 2011 6:00 pm |
|
The gear is Tecumseh 37050, EOM $70, OEM under $20. I've replaced them before but it's been a while and I forget how but it was easy. If you go that way you can work drops of light oil on the punger and do that as a maintenance point easy year. You can do what you want but I would not use it with a broken tooth. If you continue to use it more teeth will probably strip. Ring gear is probably fine but check as Shryp mentioned. A not so nice part is chipped teeth can be picked up by the flywheel magnet and jam between the flywheel and legs of the coil. The tooth may have fallen out of the cowling or be held by the magnet. It may move later. You can still pull the rope so if gone fine. if stuck to the magnet it may ride there and not move. The odds are with you but still odds. The starter bodies with welded on fork type top U's sometimes have too much play and do just what yours has. I don't think it's a major issue but I've seen a few just like yours and one that the teeth jamed between the magnet and coil leg.
This message was modified Feb 5, 2011 by trouts2
|
dcassell
Location: Boston
Joined: Feb 5, 2011
Points: 5
|
|
Re: Ariens 926PRO Electric Start Help
Reply #14 Feb 5, 2011 10:25 pm |
|
Thanks guys for all of the comments, and the parts numbers (trouts). I will not use the electric starter until I replace the gear on the starter and inspect the ring gear. In the danyboy video, he uses a special Tecumseh tool to get the gear off the starter. This tool kit is about $50. Any comments on the feasibility of doing this without the special tool set?
This message was modified Feb 5, 2011 by dcassell
|
|
|