Can you help ?
I had to replace the shear bolt on the impeller shaft and did so by tiling the blower fully up on its front end.
I noticed later that afternoon that it was slowly leaking gas from somewhere near the carbuerator.
I turned off the gas value and ran it till it stopped thinking that all the gas was used up.
Later today I again noticed a gasoline smell and think it was still coming from the bottom of the carbuerator. There is a small spring loaded button on the bowl, I pushed the button and a small amount of gas came out - I think it was coming from there. I think this is to allow someone to fully drain the bowl?
It's never done that before - any thoughts on why it started leaking and how I might fix it (if it's that push pin) or do you think it might be something else? Your help would be most appreciated.
