Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

     

I was asked to post pictures of the first oil change, so here they are:

Oil was a bit dirty, after about 7 hours use, did get a full liter out, so doesn't appear to use any, at this point.

I did not have to take all the covers off, only did to see/show what is under the hood

There are Rubber engine mounts to reduce vibration. Also rubber and foam seals, which kept the inside very clean, and reduce noise. My neighbour can not believe how quite it is.

Oil Drain and Fill Side:

Carb and Muffler Side:

Front Shot:

Just to Remember what it looks like together:

It was nice to see what was under the hood, the workmanship is Outstanding.

I ops manual gives all the Torque settings, for all the Bolts, including cover bolts, so I was able to install everything back to to specs.

I am very impressed with the attention to detail that went into building this unit.

Is that RUST around the spout in the second picture?  Look like you been neglecting that machine.  Can't give much for a machine in this condition but I'll take it off your hands for, say, $2100

I will give you $2150 cash in US currency. 

Dr_Woof wrote:

Your nuts!!! 2100, PULLLEASEE,

Being that there are none left in Saskatchewan, I would expect full MSRP, plus another $500 for testing and confirmation that it can do the Job

BY the way, thats is just residue and staining from welding the muffler.

MN_Runner wrote:

You do realize that we are almost at PAR? In Fact, we are worth about a half cent more right now

I can give you $2150 in Canadian if you like.   What time should I stop by to pick it up?  I can leave now and be there by 7AM.

MN_Runner wrote:

hmmmmm, you missed my response to Dr. Woof!!

Tell You what, since you have to drive so far I'll cut you a deal, Just Double your current Offer, and it is Yours!

let me check with the wife but in the mean time please don't wait for me.

OMG, those pictures!   Those pictures of your beauty totally uncovered...   Sorry, hard to concentrate.   Would you sell...I mean like...how much for an 8 x 10 glossy of the third photo?

Paul7 wrote:

The third picture is my favorite as well

My wife thinks I am nuts, taking pictures of a snow blower!!!

The huge cover makes more sense after seeing heat sink, wires and connections in there. 

The engine mount rubber supports a plate and I can see only one of what i think is an engine mount bolt.  How is the engine held up?  Are there 4 rubber mounts?  Is the engine only supported by the mounts or does the engine base touch the tractor base at all?