Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I have a new Honda HS928TCD blower.  Apparently a change was made in the past for the shear pins for the HS928 so now there are two types available, depending on the frame serial number. The older style pins have a P/N of  95701-06016-00 and the newer style is 92101-06016-0A. Since I have a bunch of the older style shear pins, I am wondering what the nature of the change was and if the older type of shear pins will work for the newer model.  If the old style is used on the new frame type, is there a danger to the gearcase because the shearing point is different?  See  http://www.boats.net/parts/search/Honda/Snow%20Blower/0/HS928%20WAS%20SNOW%20BLOWER%2C%20JPN%2C%20VIN%23%20SZAS-1100001%20TO%20SZAS-1129999/AUGER/parts.html for the illustrations.  Any ideas out there?

The old number is a flange head bolt the new isn't they are the same grade bolt. You can use either one.

AJ

Thanks for that AJ!  This place is amazing - only took 19 minutes to get an answer to my question!!

Good to know.  I bought a few spares last year and they were the newer kind. 

If anybody needs more of these I see they are on Ebay now - 15 bux gets 2 dozen with free shipping (in Canada).

Auger shear pins are on Ebay Canada site at:  http://cgi.ebay.ca/24-honda-2stage-snowblower-auger-shear-pins-aftermrket-/300493510285?pt=LH_DefaultDomain_2&hash=item45f6cf168d

When I went to my dealer yesterday, they told me to buy Grade 5 bolts and matching locking nuts.  It was very refreshing to hear dealer that I don't need to buy Honda shear bolts/nut combination for $2.99.  It ended up costing me around $0.70 for both bolt and nut.  So I bought 5 extra sets in addition to the three that came with the snowblower.  My dealers are very reasonable here.

Are you sure he said grade 5? Those are the ones with the 3 lines on the bolt head. Those will outlast your gearbox!  He should have said grade 2 (no lines on the head).

I would not risk using an ordinary hardware bolt for this application - even a grade 2.  Shear pins are designed to sacrificially break when your auger locks up on something hard.  Rather than the aluminum gearbox breaking.  Cost out replacing a gearbox and you will see why.

Woof,

the shear pins you are recommending via eBay are after-market bolts/nuts as they are not the OEM replacement.  my dealer stands by the Grade 5 so I am totally okay with it.   Again if you feel better buying the original Honda then go for it. 

MN_Runner wrote:
If your dealer "stands by" them, as in he'll rebuild your gearbox for free if it fails, then that's a great dealer.

I know that people have used grade 5 without any issues but it worries me.  I'd use grade 2 in a pinch but my preference would be for the shear pins specified for the machine.  Most shear pins are either grooved or pre-stressed to insure that they will fail when the proper amount of force is applied.  Also true shear pins may be easier to remove compared to regular bolts. 

Just my two cents.